Solderless connections – Part 4: Non-accessible insulation displacement (ID) connections – General requirements, test methods and practical guidance
Introduction: The two following parts of IEC 60352 are available on solderless insulation displacement connections: Part 3: Accessible insulation displacement (ID) connections – General requirements, test methods and practical guidance; Part 4: Non-accessible insulation displacement (ID) connections – General requirements, test methods and practical guidance. NOTE In this document the term "insulation displacement" is abbreviated to "ID", for example "ID connection", "ID termination". Figure 1 illustrates examples of accessible and non-accessible insulation displacement connections that clarify the difference among them. Part 4 includes requirements and relevant tests (normative) as well as a practical guidance in Annex A (informative) for non-accessible ID connections. Two test schedules are provided: the basic test schedule which applies to insulation displacement connections which conform to all prerequisites of Clause 5. It is derived from experience with successful applications of such connections; the full test schedule which applies to insulation displacement connections which do not fully conform to all prerequisites of Clause 5, for example which are manufactured using materials or finishes not included in Clause 5. This philosophy permits cost and time effective performance verification using a limited basic test schedule for established insulation displacement connections and an expanded full test schedule for connections requiring more extensive performance validation. The suit
Scope: This part of IEC 60352 is applicable to non-accessible ID connections for which the tests and measurements according to Clauses 6 through 8 are suitable and which are made with: appropriately designed ID terminations; wires having solid round conductors of 0,25 mm to 3,6 mm nominal diameter; wires having stranded conductors of 0,05 mm2 to 10 mm2 cross-sectional area; for use in electrical and electronic equipment and components. Information on materials and data from industrial experience is included in addition to the test procedures to provide electrically stable connections under prescribed environmental conditions. There are different designs and materials for ID terminations in use. For this reason, only fundamental parameters of the termination are specified, while the performance requirements of the wire and the complete connection are specified in full detail. The purpose of this document is: to determine the suitability of non-accessible ID connections under specified mechanical, electrical and atmospheric conditions; to provide a means of comparing test results when the tools used to make the connections, if any, are of different designs or manufacture.
Contents:
- FOREWORD
- INTRODUCTION
- Scope