Magnetic materials – Part 16: Methods of measurement of the magnetic properties of Fe-based amorphous strip by means of a single sheet tester
Introduction: A method of measuring the magnetic properties of Fe-based amorphous strip is required to grade what is regarded as a promising material to reduce energy loss in transformer cores and, consequently, to reduce global warming. Fe-based amorphous strip is produced by a rapidly-solidifying, direct-casting process. The strip is intended primarily for the construction of wound cores of distribution transformers for commercial power frequency (50 Hz and 60 Hz) applications. After appropriate heat treatment, the strip exhibits a significantly lower value of specific total loss compared to grain-oriented electrical steel strip. It is associated with low hysteresis loss due to low magnetic anisotropy and low eddy current loss due to high resistivity and reduced thickness. However, significant deterioration can occur by applying stress on the strip due to the large magnetostriction and low magnetic anisotropy characteristics of the material. Therefore, a method of measurement of the magnetic properties of Fe-based amorphous strip by means of a single sheet tester (SST) is required, independent of IEC 60404-3 [1]1, which is specified for electrical steel sheets. The almost exclusively applied wattmeter method is used also in this standard. However, the widely used version with the determination of the magnetic field strength from the magnetizing current (“MC method”) is not applicable to this kind of material, because the influence of the yokes on the loss measurement is significantly gre
Scope: This part of IEC 60404 is applicable to Fe-based amorphous strips specified in IEC 60404-8- 11 for the measurement of AC magnetic properties at frequencies up to 400 Hz. The object of this part is to define the general principles and technical details of the measurement of the magnetic properties of Fe-based amorphous strips by means of a single sheet tester. The single sheet tester is applicable to test specimens obtained from Fe-based amorphous strips of any quality. The AC magnetic characteristics are determined for a sinusoidal induced voltage, for specified peak values of magnetic polarization and for a specified frequency. The measurements are made at an ambient temperature of (23 ± 5) °C on test specimens which have first been demagnetized. NOTE 1 The single sheet tester specified in this document is appropriate for other materials which have magnetic properties and physical characteristics similar to those of Fe-based amorphous strip, such as nano-crystalline soft magnetic strip. The single sheet tester for electrical steel sheets is specified in IEC 60404-3. NOTE 2 Throughout this document the term “magnetic polarization” is used as described in IEC 60050-121. In some standards of the IEC 60404 series, the term “magnetic flux density” is used.
Contents:
- FOREWORD
- INTRODUCTION
- Scope