Magnetic materials – Part 8-10: Specifications for individual materials – Magnetic materials (iron and steel) for use in relays
Introduction: Fe-based amorphous strip is regarded as a promising material to reduce energy loss in transformer cores and, consequently, to help mitigate global warming. The Fe-based amorphous strip is produced by a rapidly-solidifying, direct-casting process. The strip is intended primarily for the construction of wound cores of transformers for commercial power frequency (50 Hz and 60 Hz) applications. After appropriate heat treatment, the strip exhibits a significantly lower value of specific total loss in comparison with grain-oriented electrical steel strip for the same applications. It is associated with low hysteresis loss due to low magnetic anisotropy and with low eddy current loss due to high resistivity and reduced thickness.
Scope: This part of IEC 60404 defines the grades of Fe-based amorphous strip delivered in the semi-processed state, i.e. without final heat treatment, of nominal thickness 0,025 mm. Other nominal thicknesses in the range from 0,020 mm to 0,030 mm can be specified by agreement between the manufacturer and the purchaser at the time of enquiry and order. In particular, it gives general requirements, magnetic properties, geometric characteristics, tolerances and technological characteristics, as well as inspection procedures. This document applies to the rapidly-solidified Fe-based amorphous strip supplied in coils with as-cast edges and intended for the construction of magnetic circuits. The grades are grouped into two classes: conventional grades; high permeability grades. They correspond to Class I1 of IEC 60404-1.
Contents:
- FOREWORD
- INTRODUCTION
- Scope