Magnetic Materials Part 8: Specifications for Individual Materials Section Four - Specification for Cold-Rolled Non-Oriented Magnetic Steel Sheet and Strip
Introduction: This revision of International Standard IEC 60404-8-4 has been prepared by the experts of the Working Group 1 of the IEC Technical Committee 68: Magnetic alloys and steels. The third edition of IEC 60404-8-4 was issued in 2013. After that, other IEC 60404 standards were revised and IEC TC 68 decided in 2019 at their meeting in Düsseldorf to revise this document to maintain consistency for user's convenience. The revision is made mainly on technical amendments regarding testing and definitions of geometrical characteristics in accordance with IEC 60404-9. The length of test specimen for determination of geometrical characteristics is changed from 2 m to 1 m. The term of “flatness” is divided into “edge wave (wave factor)” and “residual curvature” and the horizontal method is introduced for verification of residual curvature. This revision also includes corrections in order to improve consistency with other standards of the IEC 60404-8 series.
Scope: This part of IEC 60404 defines the grades of cold-rolled non-oriented electrical steel strip and sheet in nominal thicknesses of 0,35 mm, 0,47 mm, 0,50 mm, 0,65 mm and 1,00 mm. In particular, it gives general requirements, magnetic properties, geometric characteristics, tolerances and technological characteristics, as well as inspection procedure. The nominal thickness 0,47 mm applies to the grades for use at 60 Hz only. This document applies to cold-rolled non-oriented electrical steel strip and sheet supplied in the fully-processed state, i.e. the final annealed condition, in coils or sheets, and intended for the construction of magnetic circuits. This document does not apply to materials supplied in the semi-processed state. NOTE The cold-rolled non-oriented electrical steel strip and sheet supplied in the semi-processed state is specified in IEC 60404-8-3. The grades defined in this document correspond to Class C21 of IEC 60404-1.
Contents:
- FOREWORD
- INTRODUCTION
- Scope