Magnetic materials – Part 8-7: Specifications for individual materials – Cold-rolled grain-oriented electrical steel strip and sheet delivered in the fully-processed state
Introduction: This revision of International Standard IEC 60404-8-7 has been prepared by the experts of the Working Group 1 of the IEC technical committee 68: Magnetic alloys and steels. The insertion of a third class of electrical steels for magnetic domain refined high permeability grades is the main reason of this revision. Most of the technologies of magnetic domain refinement result in material that does not withstand the stress relief annealing after cutting without changing the magnetic properties (i.e. the specific total loss). In the case of this material, the Epstein method according to IEC 60404-2, requiring the annealing of the Epstein test specimens, is not suitable. Therefore, the single sheet tester (SST) method specified in IEC 60404-3 is employed for such non-heatproof magnetic material. The introduction of the SST as the reference measurement method for these magnetic domain refined high permeability grades was preceded by intense discussions within IEC/TC 68. The specific total loss measured by use of the SST specified in IEC 60404-3 tends to be larger than the value measured by the use of the Epstein frame in accordance with IEC 60404-2. The magnetic polarization at H = 800 A/m measured by use of the SST tends to be a little lower than the value measured by the use of the Epstein frame. The significant difference between Epstein and SST loss results made it necessary to introduce a conversion factor, Fc, applied to the SST results. This conversion factor is to create co
Scope: This part of IEC 60404 defines the grades of cold-rolled grain-oriented electrical steel strip and sheet in nominal thicknesses of 0,20 mm, 0,23 mm, 0,27 mm, 0,30 mm and 0,35 mm. In particular, it gives general requirements, magnetic properties, geometric characteristics, tolerances and technological characteristics, as well as inspection procedures. This document applies to Goss textured grain-oriented electrical steel strip and sheet supplied in the final annealed condition in coils or sheets, and intended for the construction of magnetic circuits. The grades are grouped into two three classes: conventional grades; high permeability grades, including grades which may be delivered in the domain refined condition. magnetic domain refined high permeability grades. They correspond to Class C22 of IEC 60404-1.
Contents:
- FOREWORD
- INTRODUCTION
- Scope