Guide for the statistical analysis of ageing test data – Part 1: Methods based on mean values of normally distributed test results
Introduction: Procedures for estimating ageing properties are described in specific test procedures, or are covered by the general documents on test procedures for ageing tests with a specific environmental stress (e.g. temperature, radiation, partial discharges). In many cases, a certain property is determined as a function of time at different ageing stresses, and a time to failure based on a chosen end-point criterion is found at each ageing stress. A plot of time to failure versus ageing stress may be used to obtain an estimate of the time to failure for similar specimens exposed to a specified stress, or to obtain an estimate of the value of stress which will cause failure in a specified time. The physical and chemical laws governing the ageing phenomena may often lead to the assumption that a linear relationship exists between the property examined and the ageing time at fixed ageing stresses, or between certain mathematical functions of property and ageing time, e.g. square root or logarithm. Also, there may be a linear relationship between time to failure and ageing stress, or mathematical functions of these variables. The methods described in this part of IEC 60493 apply to such cases of linear relationship. The methods are illustrated by the example of thermal ageing wherein the case of a simple chemical process it may be assumed that the degradation obeys the Arrhenius law, i.e. the logarithm of time to failure is a linear function of the reciprocal thermodynamic temperature. Nu
Scope: This part of IEC 60493 gives statistical methods which may be applied to the analysis and evaluation of the results of ageing tests. It covers numerical methods based on mean values of normally distributed test results. These methods are only valid under specific assumptions regarding the mathematical and physical laws obeyed by the test data. Statistical tests for the validity of some of these assumptions are also given. This standard deals with data from both complete test sets and censored test sets. This standard provides data treatment based on the concept of "data sub-group" as defined in Clause 3. The validity of the coefficients used in the calculation processes to derive statistical parameters of the data groups are described in [1].
Contents:
- FOREWORD
- INTRODUCTION
- Scope