IEC 60544-2-2012 PDF

IEC 60544-2-2012 PDF

Electrical insulating materials-Determination of the effects of ionizing radiation on insulating materials-Part 2: Procedures for irradiation and test

$15.77 $31.53 -50%
Product Code: IEC 60544-2
Stock In Stock
Edition: 3.0
Published: 07/2012
Number of Pages: 50
File Size: 1 file, 461 Bytes

Available Options

Product Description

Guide for determining the effects of ionizing radiation on insulating materials Part 2: Procedures for irradiation

Introduction: When selecting insulating materials for applications in radiation environments, the component designers should have available reliable test data to compare candidate materials. To be meaningful, the performance data should be obtained on each material by standardized procedures, and the procedures should be designed to demonstrate the influence that variations of the service conditions have on the significant properties. This point is of particular concern where in normal service conditions low dose rates exist and where the insulation materials have been selected from radiation endurance data obtained from tests conducted at high dose rates. Environmental conditions shall be well controlled and documented during the measurement of radiation effects. Important environmental parameters include temperature, reactive medium and mechanical and electrical stresses present during the irradiation. If air is present, radiation-induced species can enter into reactions with oxygen that would not occur in its absence. This is responsible for an observed influence of the absorbed dose rate for certain types of polymers if irradiated in air. As a result, the resistance may be several orders of magnitude lower than when the sample is irradiated under vacuum or in the presence of inert gas. This is generally called the "dose-rate effect", which is described and reviewed in references [1] to [14]1. NOTE For the user of this Part of IEC 60544 who wants to go into more detail, the cited refere

Scope: This Part of IEC 60544 specifies the controls maintained over the exposure conditions during and after the irradiation of insulating materials with ionizing radiation prior to the determination of radiation-induced changes in physical or chemical properties. This standard specifies a number of potentially significant irradiation conditions as well as various parameters which can influence the radiation-induced reactions under these conditions. The objective of this standard is to emphasize the importance of selecting suitable specimens, exposure conditions and test methods for determining the effect of radiation on appropriately chosen properties. Since many materials are used either in air or in inert environments, standard exposure conditions are recommended for both of these situations. It should be noted that this standard does not consider measurements which are performed during the irradiation.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60544-2-2012 PDF

IEC 60544-2-2012 PDF

$15.77 $31.53