Equipment Reliability Testing - Part 2: Design of Test Cycles
Introduction: A test cycle is a sequence of different operating and environmental test conditions which are based upon actual conditions of use, as defined, for example, by the relevant product specification. The equipment undergoing reliability testing is normally subjected to repeated test cycles. The number of cycles will depend on the accumulated relevant test time, as required by the selected compliance test plan of IEC 605-7, or as suitable for determination testing according to IEC 605-4. The step-by-step procedure described here is intended for any specific equipment to be tested, when it is considered necessary to simulate closely the real conditions of use of the equipment. It applies fully to laboratory testing, but may be applied to field testing, in so far as conditions can be controlled, with respect to operating conditions only (including load, supply, etc.).
Scope: This part of IEC 605 provides a general procedure for design of test cycles, where no applicable preferred test cycles can be found in IEC 605-3. It applies to the design of oper- ating and environmental test cycles referred to in 8.1 and 8.2 of IEC 605-1. The resulting test cycle should be included in the detailed reliability test specification. Tests which include cycles designed according to this standard are not intended to replace ordinary tests such as qualification tests, functional pe rformance tests and environmental tests. Pre-exposure tests may in some cases be necessary before commencing the test cycles designed by the methods of this standard. The basis of the decision as to whether to include pre-exposure tests is outside the scope of this standard.
Contents:
- FOREWORD
- INTRODUCTION
- 1 Scope
- 2 Normative references
- 5.3 Interrelationship between operating and environmental parameters