IEC 60679-3-2012 PDF

IEC 60679-3-2012 PDF

Quartz crystal controlled oscillators of assessed quality-Part 3: Standard outlines and lead connections

$100.88 $201.76 -50%
Product Code: IEC 60679-3
Stock In Stock
Edition: 3.0
Published: 12/2012
Number of Pages: 54
File Size: 1 file, 714 Bytes

Available Options

Product Description

Quartz crystal controlled oscillators of assessed quality – Part 3: Standard outlines and lead connections

Scope: This part of IEC 60679 specifies the outline dimensions and lead connections for quartz crystal controlled oscillators with lead enclosures. Guidance for the standardization of outline drawings for frequency control and selection devices In order to achieve a uniform presentation of outline drawings for frequency control and selection devices, the following shall be considered. a) An outline drawing shall show all dimensional and geometrical characteristics of an enclosure necessary to ensure mechanical interchangeability with all other enclosures of the same outline. Enlarged and detailed view may be used, if necessary. b) The outline drawing shall consist of three parts: 1) A drawing with dimensional symbols (capital letter) as shown in Figure 1 with applicable footnotes, if necessary. 2) A tabular listing relating to the drawing symbol to the actual dimensions. Where possible, this shall be shown on the same page as the drawing. 3) An "actual-size" sketch (scale 1:1). c) The outline drawing shall be executed in the third-angle projection. d) The function and identification of the lead connections (termination) shall be determined by agreement between the supplier and user. They shall not be defined on the outline drawing. e) Descriptive footnotes may be used at the bottom of/ or adjacent to, the drawing with proper reference to the body of the drawing. f) All dimensions shall be in millimeters. g) 0utline dimensions A, B, C, D and E shall be listed with maximum values only. h) If there are plural identical enclosures with different height (C), C shall be expressed with a suffix number such as C1, C2, etc. The following letter and number after the basic type number (four digits) indicate the enclosure height and lead length. The identity references are given in the table in the sheet. i) Lead (termination) cross-sectional dimensions shall be listed with minimum and maximum values. If applicable, nominal dimensions may be added. j) The spacing of the leads (termination) – symbol H – shall be listed with minimum, nominal and maximum dimensions. – 26 – 60679-3 © CEI:2012 AVANT-PROPOS ................................................................................

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60679-3-2012 PDF

IEC 60679-3-2012 PDF

$100.88 $201.76