Fire hazard testing – Part 1-21: Guidance for assessing the fire hazard of electrotechnical products – Ignitability – Summary and relevance of test methods
Introduction: Fires are responsible for creating hazards to life and property as a result of the generation of heat (thermal hazard), and also as a result of the production of toxic effluent, corrosive effluent and smoke (non-thermal hazard). Fires start with ignition and then can grow, leading in some cases to flash-over and a fully developed fire. Ignition resistance is therefore one of the most important parameters of a material to be considered in the assessment of fire hazard. If there is no ignition, there is no fire. For most materials (other than metals and some other elements), ignition occurs in the gas phase. Ignition occurs when combustible vapour, mixed with air, reaches a high enough temperature for exothermic oxidation reactions to rapidly propagate. The ease of ignition is a function of the chemical nature of the vapour, the fuel/air ratio and the temperature. In the case of liquids, the combustible vapour is produced by vaporization of the liquid, and the vaporization process is dependent on the temperature and chemical composition of the liquid. In the case of solids, the combustible vapour is produced by pyrolysis when the temperature of the solid is sufficiently high. The vaporization process is dependent on the temperature and chemical composition of the solid, and also on the thickness, density, specific heat, and thermal conductivity of the solid. The ease of ignition of a test specimen depends on many variables. Factors that need to be considered for the assessment
Scope: This part of IEC 60695 provides a summary of test methods that are used to determine the ignitability of electrotechnical products or materials from which they are formed. It also includes test methods in which, by design, ignitability is a significant quantifiable characteristic. It represents the current state of the art of the test methods and, where available, includes special observations on their relevance and use. The list of test methods is not to be considered exhaustive, and test methods which were not developed by the IEC are not to be considered as endorsed by the IEC unless this is specifically stated. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 50 W Horizontal and vertical flame test methods, IEC 60695-11-10 [19]
- 500 W flame test methods, IEC 60695-11-20 [20]
- 1 kW nominal pre-mixed flame, IEC 60695-11-2 [23]