IEC 60695-1-30-2017 PDF

IEC 60695-1-30-2017 PDF

Fire hazard testing-Part 1-30: Guidance for assessing the fire hazard of electrotechnical products-Preselection testing process-General guidelines

$50.44 $100.88 -50%
Product Code: IEC 60695-1-30
Stock In Stock
Edition: 3.0
Published: 02/2017
Number of Pages: 36
File Size: 1 file, 612 Bytes

Available Options

Product Description

Fire hazard testing – Part 1-30: Guidance for assessing the fire hazard of electrotechnical products – Preselection testing process – General guidelines

Introduction: In the design of any electrotechnical product, the risk of fire and the potential hazards associated with fire need to be considered. In this respect the objective of component, circuit and equipment design as well as the choice of materials is to reduce the risk of fire to a tolerable level even in the event of reasonably foreseeable (mis)use, malfunction or failure. IEC 60695-1-10, IEC 60695-1-11 and IEC 60695-1-12 provide guidance on how this is to be accomplished. The best method for testing electrotechnical products with regard to fire hazard is to duplicate exactly the conditions occurring in practice within a real-scale fire test. Where this is not practicable, fire hazard testing is conducted by simulating as closely as possible, the actual conditions of use and of the situation to which a sub-assembly, component, part or material may be exposed in such use. Preselection is the procedure for assessing and choosing materials, components or sub- assemblies for parts of end products. Preselection has been used for many years to assist in the design stage of the end product. The information gained from properly designed small-scale tests can be used as an aid for the preselection of appropriate materials, parts, components or sub-assemblies with regard to the fire hazard evaluation of the final end product. As an outcome of conducting a fire hazard assessment, an appropriate series of preselection flammability and ignition tests may enable reduced end product testing.

Scope: This part of IEC 60695 provides guidance for assessing and choosing candidate materials, components or sub-assemblies for making an end product based upon preselection testing. It describes how preselection provides comparative fire hazard test methods to evaluate the performance of a test specimen and how preselection can be used in the selection of materials, parts, components and sub-assemblies during the design stage of an end product. It further describes how standardized test methods may be used as one part in the decision making processes directed to minimize the fire hazards from electrotechnical equipment. It takes into account the desired reaction to fire properties of the end product, and the possible effects of environmental conditions on the behaviour of the end product. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60695-1-30-2017 PDF

IEC 60695-1-30-2017 PDF

$50.44 $100.88