IEC 60695-10-2-2014 PDF

IEC 60695-10-2-2014 PDF

Fire hazard testing-Part 10-2: Abnormal heat-Ball pressure test method

$25.22 $50.44 -50%
Product Code: IEC 60695-10-2
Stock In Stock
Edition: 3.0
Published: 02/2014
Number of Pages: 36
File Size: 1 file, 466 Bytes

Available Options

Product Description

Fire hazard testing - Part 10: Guidance and test methods for the minimization of the effects of abnormal heat on electrotechnical products involved in fires - Section 2: Method for testing products made from non-metallic materials for resistance to heat using the ball pressure test

Introduction: In the design of any electrotechnical product, the risk of abnormal heat and the potential hazards associated with abnormal heat need to be considered. In this respect the objective of component, circuit, and product design, as well as the choice of materials, is to reduce to acceptable levels the potential risks during normal operating conditions, reasonable foreseeable abnormal use, malfunction and/or failure. IEC/TC 89 has developed IEC 60695-1- 10, together with its companion, IEC 60695-1-11, to provide guidance on how this is to be accomplished. The primary aims of IEC 60695-1-10 and IEC 60695-1-11 are to provide guidance on how: a) to prevent ignition caused by an electrically energized component part, and b) to confine any resulting fire within the bounds of the enclosure of the electrotechnical product in the event of ignition. Secondary aims of IEC 60695-1-10 and IEC 60695-1-11 include the minimization of any flame spread beyond the product’s enclosure and the minimization of the harmful effects of fire effluents such as heat, smoke, toxicity and/or corrosivity. Fires involving electrotechnical products can also be initiated from external non-electrical sources. Considerations of this nature should be dealt with in the overall fire hazard assessment. This part of IEC 60695 describes a test method where the softening and accelerated material flow under load of a polymeric material is evaluated using a weighted ball-bearing in a heating oven. It should be used to measu

Scope: This part of IEC 60695 specifies the ball pressure test as a method for evaluating the softening temperature and accelerated material flow under load of polymeric materials and parts of end products in their ability to resist abnormal heat. It is applicable to the materials used in electrotechnical equipment, subassemblies and components, and to solid electrical insulating materials except ceramics. NOTE The Ball Pressure test method is not appropriate for certain elastomers, foamed materials, and other materials that tend to be soft at room temperature. Product Committees are encouraged to evaluate these materials using other methods such as IEC 60695-10-3. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60695-10-2-2014 PDF

IEC 60695-10-2-2014 PDF

$25.22 $50.44