IEC 60695-11-3-2012 PDF

IEC 60695-11-3-2012 PDF

Fire hazard testing-Part 11-3: Test flames-500 W flames-Apparatus and confirmational test methods

$132.41 $264.81 -50%
Product Code: IEC 60695-11-3
Stock In Stock
Edition: 1.0
Published: 08/2012
Number of Pages: 62
File Size: 1 file, 711 Bytes

Available Options

Product Description

Fire hazard testing – Part 11-3: Test flames – 500 W flames – Apparatus and confirmational test methods

Introduction: The best method for testing electrotechnical products with regard to fire hazard is to duplicate exactly the conditions occurring in practice. In most instances, this is not possible. Accordingly, for practical reasons, the testing of electrotechnical products with regard to fire hazard is best conducted by simulating as closely as possible the actual effects occurring in practice. Work initiated by ACOS resulted in a series of standards that make available standardized test flames covering a range of powers for the use of all product committees needing such test flames. A needle flame is described in IEC 60695-11-5, a 50 W flame is described in IEC 60695-11-4, and a 1 kW flame is described in IEC 60695-11-2. This international standard provides a description of the apparatus required to produce either of two 500 W test flames, and also provides a description of a calibration procedure to check that the test flame produced meets given requirements. Guidance on confirmatory tests for test flames is given in IEC 60695-11-40. Four 500 W test flame methods were originally specified in Edition 1 of IEC/TS 60695-11-3, with the intention that users would determine a ranking preference. This process has resulted in two of these flame methods, B and D, being withdrawn, as shown below: 500 W test flame method Flame type Gas Approximate flame height / mm Pre-mixed Methane Withdrawn Pre-mixed Methane or propane Withdrawn Method A was first published in 1994 and was based on existing hard

Scope: This part of IEC 60695-11 provides detailed requirements for the production of either of two 500 W nominal, pre-mixed type test flames. The approximate overall height of each flame is 125 mm. Two methods of producing a test flame are described: Method A uses methane. Method C can use either methane or propane. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 5.2.10 Laboratory fumehood/chamber

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60695-11-3-2012 PDF

IEC 60695-11-3-2012 PDF

$132.41 $264.81