IEC 60695-2-10 CMV-2026 PDF

IEC 60695-2-10 CMV-2026 PDF

Fire hazard testing - Part 2-10: Glowing/Hot-wire based test methods - Glow-wire apparatus and common test procedure (Commented Version)

$327.86 $655.72 -50%
Product Code: IEC 60695-2-10 CMV
Stock In Stock
Edition: 4.0
Published: 05/2026
Number of Pages: 66
File Size: 1 file

Available Options

Product Description

Fire hazard testing - Part 2-10: Glowing/Hot-wire based test methods - Glow-wire apparatus and common test procedure (Commented Version)

Introduction: In the design of any electrotechnical product, the risk of fire and the potential hazards associated with fire need to be considered. In this respect the objective of component, circuit, and product design, as well as the choice of materials, is to reduce to acceptable levels the potential risks of fire during normal operating conditions, reasonably foreseeable abnormal use, malfunction, and/or failure. IEC 60695-1-10 [2] was developed, together with its companion, IEC 60695-1-11 [3], to provide guidance on how this is accomplished. The primary aims of IEC 60695-1-10 [2] and IEC 60695-1-11 [3] are to provide guidance on how: a) to prevent ignition caused by an electrically energized component part; and b) to confine any resulting fire within the bounds of the enclosure of the electrotechnical product in the event of ignition . Secondary aims of these documents include the minimization of any flame spread beyond the product’s enclosure and the minimization of harmful effects of fire effluents such as heat, smoke, toxicity and/or corrosivity. Fires involving electrotechnical products can also be initiated from external non-electrical sources. Considerations of this nature should be dealt with in the overall fire risk assessment. In electrotechnical equipment, overheated metal parts can act as ignition sources. In glow-wire tests, a glowing wire is used to simulate such an ignition source. This part of IEC 60695 gives recommendations with regard to the glow-wire test apparatus a

Scope: This part of IEC 60695 specifies the glow-wire apparatus and common test procedure to simulate the effects of thermal stresses which may be produced by heat sources such as glowing elements or overloaded resistors, for short periods, in order to assess the fire hazard by a simulation technique. The test procedure described in this document is a common test procedure intended for the small-scale tests in which a standardized electrically heated wire is used as a source of ignition. It is a common part of the test procedures applied to end products and to solid electrical insulating materials or other solid combustible materials. A detailed description of each particular test procedure is given in IEC 60695-2-11, IEC 60695- 2-12 and IEC 60695-2-13. This basic safety publication focusing on safety test method(s) is primarily intended for use by technical committees in the preparation of safety publications in accordance with the principles laid down in IEC GUIDE 104:2019 [1] and ISO/IEC Guide 51 [4]. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60695-2-10 CMV-2026 PDF

IEC 60695-2-10 CMV-2026 PDF

$327.86 $655.72