Fire hazard testing – Part 8-1: Heat release – General guidance
Introduction: In the design of any electrotechnical product, the risk of fire and the potential hazards associated with fire need to be considered. In this respect the objective of component, circuit and equipment design as well as the choice of materials is to reduce the risk of fire to a tolerable level even in the event of reasonably foreseeable (mis)use, malfunction or failure. IEC 60695-1-10 [1]1 provides guidance on how this is to be accomplished. Fires involving electrotechnical products can be initiated from external non-electrical sources. Considerations of this nature are dealt with in an overall risk assessment. The aim of the IEC 60695 series of standards is to save lives and property by reducing the number of fires or reducing the consequences of the fire. This can be accomplished by: trying to prevent ignition caused by an electrically energised component part and, in the event of ignition, to confine any resulting fire within the bounds of the enclosure of the electrotechnical product; trying to minimise flame spread beyond the product’s enclosure and to minimise the harmful effects of fire effluents including heat, smoke, and toxic or corrosive combustion products. Fires are responsible for creating hazards to life and property as a result of the generation of heat (thermal hazard), toxic and/or corrosive compounds and obscuration of vision due to smoke. Fire risk increases as the heat released increases, possibly leading to a flash-over fire. One of the most important meas
Scope: This part of IEC 60695-8 provides guidance on the measurement and interpretation of heat release from electrotechnical products and materials from which they are constructed. Heat release data can be used as part of fire hazard assessment and in fire safety engineering, as described in IEC 60695-1-11 [2] and IEC 60695-1-12 [3]. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.
Contents:
- FOREWORD
- INTRODUCTION
- Scope