IEC 60695-9-2-2021 PDF

IEC 60695-9-2-2021 PDF

Fire hazard testing-Part 9-2: Surface spread of flame-Summary and relevance of test methods

$186.00 $371.99 -50%
Product Code: IEC 60695-9-2
Stock In Stock
Edition: 2.0
Published: 08/2021
Number of Pages: 88
File Size: 1 file, 1 Byte

Available Options

Product Description

Fire hazard testing – Part 9-2: Surface spread of flame – Summary and relevance of test methods

Introduction: In the design of an electrotechnical product, the risk of fire and the potential hazards associated with fire need to be considered. In this respect the objective of component, circuit and equipment design, as well as the choice of materials, is to reduce the risk of fire to a tolerable level even in the event of reasonably foreseeable (mis)use, malfunction or failure. IEC 60695-1-10, IEC 60695-1-11 [1]1, and IEC 60695-1-12 [2] provide guidance on how this is to be accomplished. Fires involving electrotechnical products can also be initiated from external non-electrical sources. Considerations of this nature are dealt with in an overall fire hazard assessment. The aim of the IEC 60695 series of standards is to save lives and property by reducing the number of fires or reducing the consequences of the fire. This can be accomplished by: trying to prevent ignition caused by an electrically energised component part and, in the event of ignition, to confine any resulting fire within the bounds of the enclosure of the electrotechnical product; trying to minimise flame spread beyond the product’s enclosure and to minimise the harmful effects of fire effluents including heat, smoke, and toxic or corrosive combustion products. Fire hazard increases as the burning area increases, leading in some cases to flashover and a fully developed fire. This is a typical fire scenario in buildings. It is therefore useful to measure the rate and extent of the surface spread of flame. This part of I

Scope: This part of IEC 60695-9 presents a summary of published test methods that are used to determine the surface spread of flame of electrotechnical products or materials from which they are formed. It represents the current state of the art of the test methods and, where available, includes special observations on their relevance and use. The list of test methods is not to be considered exhaustive, and test methods that were not developed by the IEC are not to be considered as endorsed by the IEC unless this is specifically stated. This summary cannot be used in place of published standards which are the only valid reference documents. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60695-9-2-2021 PDF

IEC 60695-9-2-2021 PDF

$186.00 $371.99