Household and similar electrical appliances – Test code for the determination of airborne acoustical noise – Part 2-16: Particular requirements for washer-dryers
Introduction: The noise of washer-dryers has been measured up to now by making use of two standards, IEC 60704-2-4 and IEC 60704-2-6. This first edition of IEC 60704-2-16 makes it possible to test the noise of washer-dryers by using one single standard. The following significant technical changes with respect to the separate use of IEC 60704-2-4:2011 and IEC 60704-2-6:2012 have been introduced: measurement uncertainty and standard deviations are taken into account, definition of periods and cycles, in particular definition of thermal spin period and continuous cycle, definitions of standard test programme and standard test load, location and mounting, information to be reported. The measuring conditions specified in this document provide for sufficient accuracy in determining the noise emitted and comparing the results of measurements taken by different laboratories, whilst simulating as far as possible the practical use of household washer- dryers. It is recommended to consider the determination of noise levels as part of a comprehensive testing procedure covering many aspects of the properties and performance of household washer-dryers. NOTE As stated in the introduction to IEC 60704-1, this test code is concerned with airborne noise only.
Scope: 1.1.1 General Addition: These particular requirements apply to single-unit electric washer-dryers for household and similar use intended for placing on the floor against a wall, for building-in or placing under a counter, a kitchen worktop or under a sink, for wall-mounting or on a counter. 1.1.2 Types of noise Replacement: The methods specified in ISO 3743-1, ISO 3743-2 and ISO 3744 can be used for measuring noise emitted by washer-dryers. 1.1.3 Size of the source Replacement: The method specified in ISO 3744 is applicable to noise sources of any size. When applying ISO 3743-1 and ISO 3743-2, care should be taken that the maximum size of the washer- dryers under test fulfils the requirements specified in 1.2 of ISO 3743-1:2010 and 1.3 of ISO 3743-2:1994. 1.2 Object Addition: Requirements for the declaration of noise emission values are not within the scope of this document. NOTE 101 For determining and verifying noise emission values declared in product specifications, see IEC 60704-3. 1.3 Measurement uncertainty Replacement: For washer-dryers, the estimated values of standard deviations of sound power levels, determined in accordance with this document are as indicated in Table 101 and 102. Table 101 – Standard deviations of sound power levels of washing and spinning final results for washer-dryer Standard deviation (dB) σr (repeatability) σR (reproducibility) 0,6 1,0 – 8 – IEC 60704-2-16:2019 © IEC 2019 Table 102 – Standard deviations of sound power levels of drying final results for washer-dryer Standard deviation (dB) σr (repeatability) σR (reproducibility) 0,4 0,8 1.101 Standard deviation for declaration and verification For the purpose of determining and verifying declared noise emission values for washing and spinning for washer-dryers in accordance with IEC 60704-3, the values indicated in Table 103 apply. Table 103 – Standard deviations for declaration and verification for washing and spinning final results for washer-dryer Standard deviation (dB) σP (production) σt (total) σM (reference) 1,0 to 2,2 1,4 to 2,4 2,5 For the purpose of determining and verifying declared noise emission values for drying for washer-dryers in accordance with IEC 60704-3, the
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 1.101 Standard deviation for declaration and verification
- 6.101 Standard test programme for noise measurements
- 6.102 Standard test load for noise measurements
- 8.101 Final result