Household and similar electrical appliances – Test code for the determination of airborne acoustical noise – Part 2-6: Particular requirements for tumble dryers
Introduction: The measuring conditions specified in this part of IEC 60704 provide for sufficient accuracy in determining the noise emitted and comparing the results of measurements taken by different laboratories, whilst simulating as far as possible the practical use of tumble dryers. It is recommended to consider the determination of noise levels as part of a comprehensive testing procedure covering many aspects of properties and performance of household tumble dryers. NOTE As stated in the introduction to IEC 60704-1, this test code concerns airborne noise only.
Scope: 1.1.1 General Addition: These particular requirements apply to single unit electric tumble dryers for household and similar use intended for placing on the floor against a wall, for building-in or placing under a counter, a kitchen worktop or under a sink, for wall-mounting or on a counter. For the purpose of this standard, washer-dryer combinations, when operated as a dryer, are considered as a tumble dryer. NOTE 101 For washing function, see IEC 60704-2-4. This standard is also applicable for gas-fired electric tumble dryers. 1.1.2 Types of noise Replacement: The methods specified in ISO 3743-1, ISO 3743-2 and ISO 3744 can be used for measuring noise emitted by tumble dryers. 1.1.3 Size of the source Replacement: The method specified in ISO 3744 is applicable to noise sources of any size. When applying ISO 3743-1 and ISO 3743-2, care should be taken that the maximum size of the appliance under test fulfils the requirements specified in 1.3 of ISO 3743-1 and ISO 3743-2. 1.2 Object Addition: Requirements for the declaration of noise emission values are not within the scope of this standard. NOTE 101 For determining and verifying noise emission values declared in product specifications, see IEC 60704-3. 1.3 Measurement uncertainty Replacement: 60704-2-6 IEC:2012 – 7 – The estimated values of standard deviations of sound power levels, determined according to this standard, are: Table 101 – Standard deviations of sound power levels Standard deviation dB σr (repeatability) σR (reproducibility) 0,4 0,8 Addition: 1.101 Standard deviation for declaration and verification For the purpose of determining and verifying declared noise emission values according to IEC 60704-3, the values indicated in Table 102 apply: Table 102 – Standard deviations for declaration and verification Standard deviation dB σP (production) σt (total) σM (reference) 0,7 to 1,0 1,1 to 1,3 1,5
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 6.101 Standard test programme for noise measurements
- 6.102 Standard test load for noise measurements
- 10 Information to be reported