Cable networks for television signals, sound signals and interactive services – Part 2: Electromagnetic compatibility for equipment
Introduction: Standards and deliverables of the IEC 60728 series deal with cable networks including equipment and associated methods of measurement for headend reception, processing and distribution of television and sound signals and for processing, interfacing and transmitting all kinds of data signals for interactive services using all applicable transmission media. These signals are typically transmitted in networks by frequency-multiplexing techniques. This includes, for instance: regional and local broadband cable networks, extended satellite and terrestrial television distribution systems, individual satellite and terrestrial television receiving systems, and all kinds of equipment, systems and installations used in such cable networks, distribution and receiving systems. The extent of this standardization work is from the antennas and/or special interfaces to the headend or other interface points to the network up to any terminal interface of the customer premises equipment. The standardization work will consider coexistence with users of the RF spectrum in wired and wireless transmission systems. The standardization of any user terminals (i.e. tuners, receivers, decoders, multimedia terminals, etc.) as well as of any coaxial, balanced and optical cables and accessories thereof is excluded.
Scope: This part of IEC 60728: applies to the radiation characteristics and immunity to electromagnetic disturbance of EM-active equipment (active and passive equipment) for the reception, processing and distribution of television, sound and interactive multimedia signals as dealt with in the following parts of IEC 60728 series: IEC 60728-3, Active wideband equipment for cable networks; IEC 60728-4, Passive wideband equipment for coaxial cable networks; IEC 60728-5, Headend equipment; IEC 60728-6, Optical equipment; covers the following frequency ranges: disturbance voltage injected into the mains 150 kHz to 30 MHz; radiation from active equipment 5 MHz to 25 GHz; immunity of active equipment 150 kHz to 25 GHz 1); screening effectiveness of passive equipment 5 MHz to 3,5 GHz (25 GHz) 2); specifies requirements for maximum allowed radiation, minimum immunity and minimum screening effectiveness; describes test methods for conformance testing. No measurement needs to be performed at frequencies where no requirement is specified. Due to the fact that cable networks, the former cabled distribution systems for television and sound signals, are more and more used for interactive services, these networks also incorporate equipment that carries, besides the cable network equipment ports, also one or more telecom signal port(s). This equipment is called "multimedia network equipment". The EMC behaviour of cable network equipment, telecommunication network equipment and multimedia network equipment can be described by the port structure given in Table 1: ___________ 1) For "inband immunity of active equipment" and "out-of-band immunity of active equipment", no requirements apply at present for the frequency range 3,5 GHz to 25 GHz. Methods of measurement and limits are investigated for inclusion in a future amendment or revised edition. 2) For "screening effectiveness of passive equipment", no requirements apply at present for the frequency range 3,5 GHz to 25 GHz. Methods of measurement and limits are being investigated for inclusion in a future amendment or revised edition. IEC 60728-2:2018 © IEC 2018 – 9 – Table 1 – Port structure of different network equipment Port name Cable
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 150 kHz to 30 MHz