IEC 60740-2-1993 PDF

IEC 60740-2-1993 PDF

Laminations for transformers and inductors for use in telecommunication and electronic equipment - Part 2: Specification for the minimum permeabilities of laminations made of soft magnetic metallic materials

$72.51 $145.02 -50%
Product Code: IEC 60740-2
Stock In Stock
Edition: 1.0
Published: 06/1993
Number of Pages: 42
File Size: 1 file, 1 Byte

Available Options

Product Description

Laminations for transformers and inductors for use in telecommunication and electronic equipment - Part 2: Specification for the minimum permeabilities of laminations made of soft magnetic metallic materials

Introduction: Technical committee 68 is responsible for a series of standards on materials, some of which are used to make laminations. At the joint meeting of TC 51 and TC 68 held in London in 1984, it was agreed that TC 51 should proceed with a standard for the electromagnetic properties of laminations (as defined in IEC 740) made from soft magnetic metallic materials, whilst TC 68 would prepare a standard covering soft magnetic materials without making any reference to laminations. This was subsequently published as IEC 404-8-6 (1986). This part of IEC 740 draws upon work done by TC 68 and in particular utilises the alloy class designation standardized in IEC 404-1, and tables II, Ill and IV of IEC 404-8-6.

Scope: This part of IEC 740 specifies requirements for the minimum permeabilities of laminations made of silicon-iron and nickel-iron alloys as defined by the alloy classes C2, El, E3 and E4 of IEC 404-1. In pa rticular, these requirements relate to the laminations specified in IEC 740 (future part 1). The properties specified apply to laminations in the fully heat- treated state, when measured at 50 Hz or 60 Hz and under conditions ensuring sinusoidal magnetic flux.

Contents:

  • FOREWORD
  • INTRODUCTION
  • 1 Scope
  • 2 Normative references
  • 3 Terms and definitions
  • 3.1 Alloy subclass
  • 3.2 Magnetic grade
  • 7.1 Minimum lamination permeability, µlam(min)
  • 7.2 Inductance factor, AL
  • 7.3 Permeability rise factor, 6
  • 8.1 General
  • 8.2 Principle of the calculation
  • 8.3 Procedure
  • 8.4 Numerical example

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60740-2-1993 PDF

IEC 60740-2-1993 PDF

$72.51 $145.02