IEC 60748-4-3-2006 PDF

IEC 60748-4-3-2006 PDF

Semiconductor devices-Integrated circuits-Part 4-3: Interface integrated circuits-Dynamic criteria for analogue-digital converters (ADC)

$163.93 $327.86 -50%
Product Code: IEC 60748-4-3
Stock In Stock
Edition: 1.0
Published: 08/2006
Number of Pages: 42
File Size: 1 file, 465 Bytes

Available Options

Product Description

Semiconductor devices – Integrated circuits – Part 4-3: Interface integrated circuits – Dynamic criteria for analogue-digital converters (ADC)

Introduction: The use of ADCs has increased significantly in the last few years with the large increase in the use of digital signal processing. The majority of the processing of analogue signals now takes place in the digital domain, and this requires high precision in the conversion of signals from the analogue to the digital form. Consequently, the characterization of ADCs is of great importance. IEC 60748-4 contains measuring methods for ADCs in which the test conditions are either static or change very slowly. However, some of the characteristics of an ADC can change to some degree with the rate of change of the input signal, and there are other characteristics that cannot be measured except under dynamic conditions. Consequently, a set of dynamic tests is required in order to obtain the response of an ADC when operated under dynamic conditions. The output of a dynamic test consists of the set of output code values obtained during the test. This record, being the sequence in time of a set of values, gives information in the “time- domain”. The result of applying the Fourier Transform to the record is information that is in the “frequency domain”, and this contains the spectrum of the output over the range of frequencies of interest. In particular, distortion, noise and spurious output frequencies can then be evaluated. This International Standard introduces a set of dynamic methods, which are now coming into use in industry and which rely mostly on measurements made with sinusoidal in

Scope: This part of IEC 60748 specifies a set of measuring methods and requirements for testing ADCs under dynamic conditions, together with associated terminology and characteristics.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60748-4-3-2006 PDF

IEC 60748-4-3-2006 PDF

$163.93 $327.86