Semiconductor devices - Mechanical and climatic test methods - Part 34-1: Power cycling test for power semiconductor module
Introduction: A power semiconductor module is affected by thermal and mechanical stress due to the power dissipation of the internal semiconductor dies and connectors. This occurs when low-voltage operating bias for forward conduction is periodically applied and removed, causing rapid changes in temperature. The power cycling test is intended to simulate the temperature swing in typical power electronics applications, which is different from the stable temperatures reached under the high temperature operating life (HTOL) test as shown in IEC 60749-23. Exposure to the power cycling test would not induce the same failure mechanisms as exposure to the thermal cycling test, or thermal shock test. The power cycling test is a destructive test that will cause wear-out failure of the device under test (DUT) if it is driven above the specification of the device. The power cycling test is applied to general power semiconductor modules such as for example those used for motor control, robots, and renewable energy generation. The power cycling test has two modes: a short-time test (based on a short cycle time) that simulates rapid acceleration and deceleration of the equipment, and a long-time test (based on a long cycle time) that simulates repeated operation and stop of the equipment. The short-time test mainly verifies the effect of the temperature change of virtual junction temperature (Tvj) and causes the deterioration of the joint between the semiconductor die and the wire, and that of the die a
Scope: This part of IEC 60749 describes a test method that is used to determine the capability of power semiconductor modules to withstand thermal and mechanical stress resulting from cycling the power dissipation of the internal semiconductors and the internal connectors. It is based on IEC 60749-34, but is developed specifically for power semiconductor module products, including insulated-gate bipolar transistor (IGBT), metal-oxide-semiconductor field-effect transistor (MOSFET), diode and thyristor. If there is a customer request for an individual use or an application specific guideline (for example ECPE Guideline AQG 324), details of the test method can be based on these requirements if they deviate from the content of this document. This test causes wear-out and is considered destructive.
Contents:
- FOREWORD
- INTRODUCTION
- Scope