Test on gases evolved during combustion of materials from cables – Part 2: Determination of acidity (by pH measurement) and conductivity
Introduction: IEC 60754 consists of the following parts, under the general title Test on gases evolved during combustion of materials from cables: Part 1: Determination of the halogen acid gas content Part 2: Determination of acidity (by pH measurement) and conductivity. Part 3: Measurement of low level of halogen content by ion chromatography IEC 60754-2 was originally developed due to concerns expressed by cable users over the amount of acid gas evolved when some cable insulating, sheathing and other materials are burned, as such corrosive effluent can cause extensive damage to electrical and electronic equipment not involved in the fire itself. NOTE Guidance on the corrosivity of fire effluent is given in IEC 60695-5-1. This standard provides a method for determining the acidity (by pH measurement) and conductivity of an aqueous solution of gases evolved during the combustion of materials so that limits can be agreed for cable specifications. As the test is not carried out on a complete cable test piece, for a hazard assessment the actual material volumes of the cable components should be taken into consideration. The method provides an indirect assessment of corrosivity. However, the recommended limits of pH and conductivity can only be regarded as an indication, as the relationship between corrosion and these two parameters does not necessarily embrace all materials. This part of IEC 60754 is linked with both IEC 60754-1, but the test procedure differs considerably and IEC 60754-3. Th
Scope: This part of IEC 60754 specifies the apparatus and procedure for the determination of the potential corrosivity of gases evolved during the combustion of materials taken from electric or optical fibre cable constructions by measuring the acidity (pH) and conductivity of an aqueous solution resulting from the gases evolved during the combustion. The heating (combustion) procedure of this part of IEC 60754 is the same as in IEC 60754-3. The general method specified in this standard is intended for the testing of individual components used in a cable construction. Formulae are given for the calculation of a weighted value for a combination of materials found in a specified cable. The use of this method will enable the verification of relevant requirements for either individual components or combined components of a cable construction stated in the appropriate cable specification. A simplified method is included for the testing of individual components where it is required only to demonstrate compliance with a stated performance requirement for quality control purposes. NOTE 1 The relevant cable standard should indicate which components of the cable should be tested, and which method of calculation (see Clause 8) should be used in the case of dispute. NOTE 2 This test method may be used to test materials to be used in cable manufacture, but a declaration of cable performance should not be made based on such a test. NOTE 3 For the purposes of this standard, the term “electric cable” covers all insulated metallic conductor cables used for the conveyance of energy or signals.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 5.10 Conductivity measuring device
- 10 Test report