Optical fibres – Part 1-48: Measurement methods and test procedures – Polarization mode dispersion
Introduction: Polarization mode dispersion (PMD) causes an optical pulse to spread in the time domain. This dispersion could impair the performance of a telecommunications system. The effect can be related to differential phase and group velocities and corresponding arrival times δτ of different polarization components of the signal. For a sufficiently narrow band source, the effect can be related to a differential group delay (DGD), ∆τ, between pairs of orthogonally polarized principal states of polarization (PSP) at a given wavelength. For broadband transmission, the delays bifurcate and result in an output pulse that is spread out in the time domain. In this case, the spreading can be related to the average of DGD values. In long fibre spans, DGD is random in both time and wavelength since it depends on the details of the birefringence along the entire fibre length. It is also sensitive to time-dependent temperature and mechanical perturbations on the fibre. For this reason, a useful way to characterize PMD in long fibres is in terms of an average DGD value over an appropriately large optical frequency range, either RMS <∆τ>, the rms DGD over this frequency range, or MEAN <∆τ>, the (linear) mean of the DGD over this same frequency range. In principle, the average DGD value (RMS <∆τ> or MEAN <∆τ>) does not undergo large changes for a given fibre from day to day or from source to source, unlike the parameters δτ or ∆τ. In addition, the average DGD value is a useful predictor of lightwave
Scope: This part of IEC 60793 applies to three methods of measuring polarization mode dispersion (PMD), which are described in Clause 4. It establishes uniform requirements for measuring the PMD of single-mode optical fibre, thereby assisting in the inspection of fibres and cables for commercial purposes.
Contents:
- FOREWORD
- INTRODUCTION
- Scope