Live working – Insulating sticks and attachable devices – Part 2: Attachable devices
Introduction: The purpose of this standard is to provide essential requirements. Each user of this standard may supplement it with their own requirements. For example, the user may add requirements regarding the use of attachable devices on d.c. electrical installations or the mechanical performance or compatibility and interchangeability with tools already in service. In such cases, caution should be taken to maintain or improve the performance of the products. This publication has been prepared in accordance with the requirements of IEC 61477. The products designed and manufactured according to this standard contribute to the safety of the users provided they are used by skilled persons, in accordance with safe methods of work and the instructions for use. The product covered by this standard may have an impact on the environment during some or all stages of its life cycle. These impacts can range from slight to significant, be of short-term or long-term, and occur at the global, regional or local level. Except for a disposal statement in the instructions for use, this standard does not include requirements and test provisions for the manufacturers of the product, or recommendations to the users of the product for environmental improvement. However, all parties intervening in its design, manufacture, packaging, distribution, use, maintenance, repair, reuse, recovery and disposal are invited to take account of environmental considerations.
Scope: This part of IEC 60832 gives the essential requirements for devices that can be attached onto and removed from the fitting of the insulating sticks for live working, for use on a.c. electrical installations. Part 1 of IEC 60832 covers insulating sticks. In this part of the standard, the term “device” is used for “attachable device”, unless otherwise specified. Products designed and manufactured according to this standard contribute to the safety of the users provided they are used by skilled persons, in accordance with safe methods of work and the instructions for use.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 5.6.10 Holding fork – Bending test
- 5.6.11 Retaining device installer/remover – Bending test
- 5.6.12 Binding wire cutter blade (tie wire cutter) – Bending test
- 5.6.13 Rotary blade – Tension test
- 5.6.14 Rotary prong – Tension test
- 5.6.15 Adjustable pliers
- 5.6.16 Vice-grip pliers
- 5.6.17 Adjustable insulator fork
- 5.6.18 All-angle pliers
- 5.6.19 Pin holder
- 5.6.20 Flexible spanner head (flexible wrench head) – Torsion test
- 5.6.21 Ammeter holder
- 5.6.22 Anti-interference braid applicator
- 5.6.23 Hack saw – Bending test