IEC 60835-2-10-1992 PDF

IEC 60835-2-10-1992 PDF

Methods of measurement for equipment used in digital microwave radio transmission systems - Part 2: Measurements on terrestrial radio-relay systems - Section ten: Overall system performance

$25.22 $50.44 -50%
Product Code: IEC 60835-2-10
Stock In Stock
Edition: 1.0
Published: 12/1992
Number of Pages: 24
File Size: 1 file, 872 Bytes

Available Options

Product Description

Methods of measurement for equipment used in digital microwave radio transmission systems - Part 2: Measurements on terrestrial radio-relay systems - Section ten: Overall system performance

Introduction: In previous sections of IEC 835-2 measurement methods for parameters of the digital radio-relay system have been discussed separately for each part of the system. In addition to these tests, the overall performance of a complete simulated system should be tested. The tests cover the two basic parameters of digital transmission systems, bit-error ratio and jitter, as well as the acceptable input interruption and verification of the protection switching operation, which are all affected by the presence of more than one radio channel and/or radio hop. The measurement of other additional parameters such as error-free seconds, burst-error ratio, block-error ratio, which remain under consideration by other international organizations, may also be required.

Scope: This section IEC 835-2 deals with measurements to be carried out during factory acceptance tests and type approval tests on a complete simulated digital radio-relay system, following tests on the individual parts of the system. In the following, it will be stated for each parameter whether or not a multi-hop measure- ment is required in the overall system performance test, depending on the cumulative or non-cumulative property of that parameter. In this section, the emphasis is on the system configuration. For methods of measurement, see under the appropriate future sections of IEC 835-1 and IEC 835-2.

Contents:

  • FOREWORD
  • INTRODUCTION
  • 1 Scope
  • 3.1 Bit-error ratio versus receiver input level
  • 3.2 Residual bit-error ratio at nominal receiver input level
  • 3.3 Bit-error ratio degradation due to multi-channel interference
  • 3.4 Bit-error ratio degradation due to multipath propagation and multi-channel

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60835-2-10-1992 PDF

IEC 60835-2-10-1992 PDF

$25.22 $50.44