IEC 60835-2-11-1996 PDF

IEC 60835-2-11-1996 PDF

Methods of measurement for digital microwave radio transmission systems - Part 2: Measurements on terrestrial radio-relay systems - Section 11: Cross-polarization interference canceller

$72.51 $145.02 -50%
Product Code: IEC 60835-2-11
Stock In Stock
Edition: 1.0
Published: 10/1996
Number of Pages: 44
File Size: 1 file, 1 Byte

Available Options

Product Description

Methods of measurement for digital microwave radio transmission systems - Part 2: Measurements on terrestrial radio-relay systems - Section 11: Cross-polarization interference canceller

Introduction: To make a more efficient use of the radio spectrum, multi-state modulation techniques are employed. These techniques have improved the spectral efficiency of the radio channel by increasing the number of modulation states for example 16 QAM, 64 QAM or 256 QAM. Another attractive method for achieving the high spectral efficiency is to transmit two different signals simultaneously on orthogonal polarizations at the same nominal carrier frequency over the same hop. This method may double the transmission capacity of digital radio systems but there is a limited isolation between the signals because the orthogonal polarization cannot be perfectly achieved due to imperfect waveguide and antenna alignments. Moreover, that limited isolation is still further reduced by various conditions such as multipath propagation or rainfall, and is of a time-variant nature. Consequently, dual-polarized channels sharing the same nominal carrier frequency face mutual inter- ference. Therefore, in the case of high multi-state modulation, it is necessary to use adaptive countermeasures against the cross-polarization interference. In practice, such cross-polarization interference cancellers (XPICs) are usually included in demodulators. Adaptive XPICs consist of i.f. or baseband transversal filters in order to handle dispersive signals and interference due to multipath propagation. Moreover, there are two kinds of transversal filters. One is the baud-space transversal filter and the other is the fracti

Scope: This section of IEC 835-2 deals with measurement for cross-polarization interference cancellers (XPIC) used in digital microwave radio-relay systems.

Contents:

  • FOREWORD
  • INTRODUCTION
  • 1 Scope
  • 2 Normative reference
  • 3 Static characteristics
  • 3.1 C/N versus cross-polarization isolation (XPI) (flat fading condition)
  • 3.2 XPI (or improvement factor) versus delay difference
  • 3.3 XPI (or improvement factor) versus notch depth with dispersive signals
  • 4 Dynamic characteristics
  • 4.1 General considerations
  • 4.2 Method of measurement
  • 4.3 Presentation of results
  • 4.4 Details to be specified
  • 1 Example of cross-polar interference canceller operation
  • 2 Example of the structure of cross-polar interference canceller
  • 3 Set-up for C/N versus XPI measurement
  • 4 Example for C/N versus XPI measurement result
  • 5 Set-up for XPI or improvement factor versus delay difference measurement
  • 6 Example of measurement results of XPI and of improvement factor versus
  • 7 Set-up for measurement of dispersive conditions
  • 8 Example of measurement results of XPI and improvement factor
  • 9 Illustration of sweep waveform for the measurement of dynamic characteristics
  • 10 Example of measurement result of dynamic characteristics

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60835-2-11-1996 PDF

IEC 60835-2-11-1996 PDF

$72.51 $145.02