IEC 60835-3-4-1993 PDF

IEC 60835-3-4-1993 PDF

Methods of measurement for equipment used in digital microwave radio transmission systems - Part 3: Measurements on satellite earth stations - Section 4: Low noise amplifier

$15.77 $31.53 -50%
Product Code: IEC 60835-3-4
Stock In Stock
Edition: 1.0
Published: 04/1993
Number of Pages: 18
File Size: 1 file, 497 Bytes

Available Options

Product Description

Methods of measurement for equipment used in digital microwave radio transmission systems - Part 3: Measurements on satellite earth stations - Section 4: Low noise amplifier

Introduction: When the low noise amplifier is measured as part of a sub-system, the input and output ports of the amplifier should be defined, and any associated networks such as r.f. filters, switches or directional couplers should be specified. The level of the test signal applied to the input of the low noise amplifier should be low enough to ensure that the amplifier is not driven into compression, or above the operating point at which damage may occur. Throughout all of the following measurements, stability of the amplifier under test should be verified (e.g. when switching from one signal source or load to another, or when overloaded to a specified extent). Alternatively, the amplifier should return automatically to a stable operating point after the switching operation, or when the overloading signal is removed.

Scope: This section of IEC 835-3 describes methods of measurement on low noise amplifiers used in satellite earth stations.

Contents:

  • FOREWORD
  • INTRODUCTION
  • 1 Scope
  • 2 Normative references
  • 3 Noise temperature

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60835-3-4-1993 PDF

IEC 60835-3-4-1993 PDF

$15.77 $31.53