IEC 60835-3-6-1996 PDF

IEC 60835-3-6-1996 PDF

Methods of measurement for equipment used in digital microwave radio transmission systems - Part 3: Measurements on satellite earth stations - Section 6: High power amplifiers

$25.22 $50.44 -50%
Product Code: IEC 60835-3-6
Stock In Stock
Edition: 1.0
Published: 03/1996
Number of Pages: 28
File Size: 1 file, 862 Bytes

Available Options

Product Description

Methods of measurement for equipment used in digital microwave radio transmission systems - Part 3: Measurements on satellite earth stations - Section 6: High power amplifiers

Introduction: Power amplifiers need to deliver a microwave signal of sufficient output power. This signal should be produced with maximum efficiency and reliability and with minimum distortion. Generally, there are two categories of amplifiers, tubes and semiconductor devices. Among the tubes, klystrons and travelling-wave tubes (TWT) are the most frequently employed; semiconductor amplifiers normally include field-effect transistors (FET). Travelling-wave tubes (TWT) and GaAs-field-effect transistors (FET) are most frequently used in satellite earth stations. Power amplifiers should have a flat gain over the specified bandwidth to avoid altering the overall transfer characteristics of a system. They should also be as linear as possible to avoid generation of sidelobes in the power spectrum and to limit adjacent channel interference. Finally, low AM to PM conversion and low intermodulation products are necessary to limit the degradation caused by non-linearities.

Scope: This section of IEC 835-3 defines and describes the measurements normally carried out on high-power amplifiers used in satellite earth station transmitters.

Contents:

  • FOREWORD
  • INTRODUCTION
  • 1 Scope
  • 2 Normative references
  • 10 Unwanted radiation (leakage)

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60835-3-6-1996 PDF

IEC 60835-3-6-1996 PDF

$25.22 $50.44