Live working – Insulating foam-filled tubes and solid rods – Part 1: Tubes and rods of a circular cross-section
Introduction: This part of IEC 60855 has been prepared in accordance with the requirements of IEC 61477. The product covered by this part of IEC 60855 may have an impact on the environment during some or all stages of its life cycle. These impacts can range from slight to significant, be short-term or long-term, and occur at the global, regional or local level. This part of IEC 60855 does not include requirements and test provisions for the manufacturers of the product, or recommendations to the users of the product for environmental improvement. However, all parties intervening in its design, manufacture, packaging, distribution, use, maintenance, repair, reuse, recovery and disposal are invited to take account of environmental considerations. Technical committee 78 is considering the preparation of IEC 60855-2, which would cover foam-filled tubes and solid rods of cross-section other than circular.
Scope: This part of IEC 60855 is applicable to insulating foam-filled tubes and solid rods, of a circular cross-section, made of synthetic materials with reinforced fibreglass and intended to be used in the manufacture and construction of tools, devices and equipment for carrying out live working on electrical systems operating at voltages above 1 kV. Foam-filled tubes and solid rods of cross-section other than circular and/or made with material other than synthetic materials with reinforced fibreglass are not covered by this part of IEC 60855.
Contents:
- FOREWORD
- INTRODUCTION
- Scope