IEC 60917-2-3-2006 PDF

IEC 60917-2-3-2006 PDF

Modular order for the development of mechanical structures for electronic equipment practices-Part 2-3: Sectional specification-Interface co-ordination dimensions for the 25 mm equipment practice-Extended detail specification-Dimensions for subracks, chassis, backplanes, front panels and plug-in units

$163.93 $327.86 -50%
Product Code: IEC 60917-2-3
Stock In Stock
Edition: 1.0
Published: 05/2006
Number of Pages: 42
File Size: 1 file, 1 Byte

Available Options

Product Description

Modular order for the development of mechanical structures for electronic equipment practices – Part 2-3: Sectional specification – Interface co-ordination dimensions for the 25 mm equipment practice – Extended detail specification – Dimensions for subracks, chassis, backplanes, front panels and plug-in units

Introduction: The dimensions in the detail specification for the 25 mm equipment practice standard are laid down in the IEC 60917-2 series. Significant progress in electronics circuitry, with increasing signal speed and the demand for high availability of the electronics systems, has made an impact on the structural parts of the equipment, as specified in IEC 60917-2-2. a) Considerations on the general tendency of the enclosure system At the moment, the general tendencies of the enclosure system for telecom/IT equipment application and associated application are considered to be: the changing form of conventional centralized networking for telecommunication to flexible distributed networking to realize ubiquitous communication and computing environment by broad-band/IP and photonics-networking-based technology; flexible configuration of networking equipment from the open market is requested; a scalable and high-performance packaging/enclosure system is requested for new networking equipment; in addition, such a packaging/enclosure system will be widely applied for general electronic equipment, because IP networking technology is becoming one of the common interfaces for all of industrial systems. Consequently, the following general requirements for the new enclosure system arise. Standard-based but various sized networking/IT equipment from the open market should be installed in one cabinet (see figure 1). The mass volume of copper/optical cables from the equipment should be managed in the

Contents:

  • FOREWORD
  • INTRODUCTION
  • 10 Electrostatic discharge provision for plug-in units and subracks
  • 10.1 ESD contact interface dimensions
  • 10.2 ESD strip interface dimensions
  • 11 Subrack dimensions for rear-mounted plug-in units

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60917-2-3-2006 PDF

IEC 60917-2-3-2006 PDF

$163.93 $327.86