IEC 60953-0-2022 PDF

IEC 60953-0-2022 PDF

Rules for steam turbine thermal acceptance tests-Part 0: Wide range of accuracy for various types and sizes of turbines

$255.36 $510.71 -50%
Product Code: IEC 60953-0
Stock In Stock
Edition: 1.0
Published: 05/2022
Number of Pages: 214
File Size: 1 file, 6 Bytes

Available Options

Product Description

Rules for steam turbine thermal acceptance tests – Part 0: Wide range of accuracy for various types and sizes of turbines

Introduction: The continuing development of measuring techniques, the increasing capacity of steam turbines and increasing variety of steam turbine configurations has necessitated a revision of IEC 60953:1990. Since all the needs of the power industry could not be satisfied by one single performance test standard covering the requirements for all of the steam turbine configurations and accuracy, the revision to this standard is based upon one reference standard and various supplementary parts as indicated below: 1) Basic philosophy and figures on uncertainty IEC 60953-0 provides for acceptance tests of steam turbines of various types and capacities with corresponding measuring uncertainty, it is based upon the Method B of IEC 60953- 2:1990. Additional and alternative guidance will be given for specific steam turbine applications in the supplementary standards where it is required. Instrumentation and measuring procedures are chosen accordingly from a scope specified in the standard series which is centred mainly on standardized instrumentation and procedures, but may extend up to high accuracy provisions requiring calibration of flow measuring devices. The resulting measuring uncertainty of the test result is then determined by calculating methods presented in the standard series and normally, if not stated otherwise in the contract, taken into account in the comparison between test result and guarantee value. The total cost of an acceptance test can therefore be maintained in relationship

Scope: 1.1 General The rules given in this document are applicable to thermal acceptance tests covering a wide range of accuracy on steam turbines of every type, rating and application. Only the relevant portion of these rules will apply to any individual case. The rules provide for the testing of turbines, whether operating with either superheated or saturated steam. They include measurements and procedures required to determine specific enthalpy within the moisture region and describe precautions necessary to permit testing while respecting radiological safety rules in nuclear plants. Uniform rules for the preparation, carrying out, evaluation, comparison with guarantee and calculation of measuring uncertainty of acceptance tests are defined in this standard. Details of the conditions under which the acceptance test can take place are included. Should any complex or special case arise which is not covered by these rules, appropriate agreement is to be reached by manufacturer and purchaser before the contract is signed. 1.2 Object The purpose of the thermal acceptance tests of steam turbines and turbine cycles described in this document is to verify guarantees given by the manufacturer of the equipment concerning: Efficiency guarantees a) Thermal efficiency; b) Heat rate; c) Thermodynamic efficiency; d) Steam rate; e) Power output. Capacity guarantees a) Main steam flow capacity; b) Maximum power output at specified steam conditions according to IEC 60045-1 (other than steam flow); c) Nuclear: thermal load capacity of the steam turbine under defined conditions. The guarantees with their provisions are formulated completely and without contradictions (see 3.4). The acceptance tests may also include such measurements as are necessary for corrections according to the conditions of the guarantee and checking of the results. – 12 – IEC 60953-0:2022 © IEC 2022 1.3 Matters to be considered in the contract Some matters in these rules are to be considered at an early stage. Such matters are dealt with in the following subclauses: Subclause 1.1 (paragraph 4) 1.2 (paragraph 2) 4.1 (paragraph 3 and 4) 4.3.2 (paragraph 1) 7.6 7.8 7.9 (paragraph 1)

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60953-0-2022 PDF

IEC 60953-0-2022 PDF

$255.36 $510.71