IEC 60994-1991 PDF

IEC 60994-1991 PDF

Guide for Field Measurement of Vibrations and Pulsations in Hydraulic Machines (Turbines, Storage Pumps and Pump-Turbines)

$239.59 $479.18 -50%
Product Code: IEC 60994
Stock In Stock
Edition: 1.0
Published: 1991
Number of Pages: 136
File Size: 1 file, 5 Bytes

Available Options

Product Description

Guide for Field Measurement of Vibrations and Pulsations in Hydraulic Machines (Turbines, Storage Pumps and Pump-Turbines)

Introduction: On a machine in service, pulsations and vibrations which cannot be avoided and which do not affect by themselves the service life of the plant where they occur, can always be observed. Their values depend on many factors, among which are the flow pattern in the water passages under different operating conditions of the unit, peculiarities of the design as well as the thoroughness of manufacture, erection and maintenance. Such pulsations and vibrations can be considered as detrimental only when certain parts of the machine or of the plant are subject to forces that may impair its resistance or when unacceptable disturbances are carried to its environment. In extreme cases, vibrations in hydraulic machines can result in the formation of cracks and even in fracture of components due to fatigue*. Excessive vibration in hydraulic machines not only can reduce their trouble-free service life but can also affect operation of governing systems and instruments, the behaviour of the attached structures and the health of personnel. Measurement of pulsation and vibration characteristics or, preferably, of their effects is to be carried out in accordance with this guide which also gives the information necessary to derive the value of the physical quantities from the readings of the measuring instruments. Given the present state of knowledge, it can only be hoped that measurements made in compliance with this guide will reveal a basic characteristic making it possible to relate pulsations

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 2.2 Terms
  • 2.4 Classification of hydraulic machines
  • 4.1 Operating conditions under which measurements are performed
  • 4.2 Checks on the machine before the beginning of tests
  • 5.2 Vibration and pulsation quantities to be measured and locations of measuring
  • 5.4 Agreement of test procedure
  • 5.5 Test programme
  • 5.7 Observations
  • 6.8 Guide vane torque pulsations
  • 6.10 Axial thrust pulsations measured at the thrust bearing
  • 6.11 Measured quantities defining the machine operating point

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60994-1991 PDF

IEC 60994-1991 PDF

$239.59 $479.18