IEC 61000-4-17-2009 PDF

IEC 61000-4-17-2009 PDF

Electromagnetic compatibility (EMC)-Part 4-17: Testing and measurement techniques-Ripple on d.c. input power port immunity test

$107.19 $214.37 -50%
Product Code: IEC 61000-4-17
Stock In Stock
Edition: 1.2
Published: 01/2009
Number of Pages: 34
File Size: 1 file, 915 Bytes

Available Options

Product Description

Electromagnetic compatibility (EMC) – Part 4-17: Testing and measurement techniques – Ripple on d.c. input power port immunity test

Introduction: This standard is part of the IEC 61000 series, according to the following structure: Part 1: General General considerations (introduction, fundamental principles) Definitions, terminology Part 2: Environment Description of the environment Classification of the environment Compatibility levels Part 3: Limits Emission limits Immunity limits (in so far as they do not fall under the responsibility of the product committees) Part 4: Testing and measurement techniques Measurement techniques Testing techniques Part 5: Installation and mitigation guidelines Installation guidelines Mitigation methods and devices Part 6: Generic standards Part 9: Miscellaneous Each part is further subdivided into several parts, published either as International Standards or technical reports, some of which have already been published as sections. Others will be published with the part number followed by a dash and a second number identifying the subdivision. This part is an International Standard which gives test procedures related to ripple on d.c. input power port.

Scope: This part of IEC 61000 defines test methods for immunity to ripple at the d.c. input power port of electrical or electronic equipment. This standard is applicable to low-voltage d.c. power ports of equipment supplied by external rectifier systems, or batteries which are being charged. The object of this standard is to establish a common and reproducible basis for testing, in a laboratory, electrical and electronic equipment when subjected to ripple voltages such as those generated by rectifier systems and/or auxiliary service battery chargers overlaying on d.c. power supply sources. This standard defines test voltage waveform; range of test levels; test generator; test set-up; test procedure. The test described hereafter applies to electrical or electronic equipment and systems. It also applies to modules or subsystems whenever the equipment under test (EUT) rated power is greater than the test generator capacity specified in clause 6. This test does not apply to equipment connected to battery charger systems incorporating switch mode converters. This standard does not specify the tests to be applied to particular apparatus or systems. Its main aim is to give a general basic reference to IEC product committees. These product committees (or users or manufacturers of equipment) remain responsible for the appropriate choice of the test and the severity level to be applied to their equipment. Dedicated test procedures are in use for testing specific categories of electrical or electronic equipment, e.g. equipment connected to d.c. supply network of telephone switching centres; the related product committees should evaluate the relevance and applicability of the test procedure specified in this basic standard. 61000-4-17 © IEC:1999+A1:2001 – 7 – +A2:2008

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Test report

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61000-4-17-2009 PDF

IEC 61000-4-17-2009 PDF

$107.19 $214.37