Industrial-process control systems - Instruments with analogue inputs and twoor multi-position outputs - Part 1: Methods for evaluating performance
Introduction: The methods of evaluation specified in this part of IEC 61003 are intended for use by manufacturers to determine the performance of their products and by users, or independent testing establishments, to verify the manufacturer's performance specifications. The test conditions in this standard, for example the range of ambient temperatures and power supply, represent those, which commonly arise in use. The tests specified in this standard are not necessarily sufficient for instruments specifically designed for unusually arduous duties. Conversely, a restricted series of tests may be suitable for instruments designed to perform within a more limited range of conditions. It will be appreciated that the closest communication should be maintained between the evaluating body and the manufacturer. Note should be taken of the manufacturer's specifications for the instrument, when the test program is being decided, and the manufacturer should be invited to comment on both the test program and the results. His comments on the results should be included in any report produced by the testing organization.
Scope: This part of IEC 61003 is applicable to pneumatic and electric industrial-process instruments or control device using measured values that are continuous signals either a mechanical (position, force, etc.) or a standard electric signal. These instruments or process control systems modules may be used as controllers or as switches for alarm and other similar purposes. Electronic product safety issues may impact only a few products covered by this document. Consequently this document does not address such safety issues. This standard is intended to specify uniform terminologies and testing methods for performance evaluation of industrial-process instruments or process control systems modules with analogue measured values and two- or multi-position outputs. Considerations other than the performances are listed in Clause 10.
Contents:
- FOREWORD
- INTRODUCTION
- Scope