IEC 61057-2017 PDF

IEC 61057-2017 PDF

Live working - Insulating aerial devices for mounting on a chassis

$239.59 $479.18 -50%
Product Code: IEC 61057
Stock In Stock
Edition: 2.0
Published: 06/2017
Number of Pages: 182
File Size: 1 file, 2 Bytes

Available Options

Product Description

Live working - Insulating aerial devices for mounting on a chassis

Introduction: This document covers insulating aerial devices for use at temperatures between −25 °C and +55 °C. Where aerial devices are for use in unusual atmospheric conditions (for example, higher or lower temperatures), other considerations may be appropriate and will be identified by the manufacturer both in the markings and instructions for use. The products covered by this document are primarily intended to be used for live working or for work within the live working zone. It recognizes that a user may specify a product, or products complying with this document where there is a risk of accidental contact with live (energized) part(s). In such circumstances users are reminded that national or local regulations regarding maintaining of Minimum Approach Distances to live parts, or those obtained from IEC 61472 are to be applied. Annex A of this document gives advice and information. The product covered by this document may have an impact on the environment during some or all stages of its life cycle. These impacts can range from slight to significant, be short-term or long-term, and occur at the global, regional or local level. Except for a disposal statement in the Instructions for use, this document does not include requirements and test provisions for the manufacturers of the product, or recommendations to the users of the product for environmental improvement. However, all parties intervening in its design, manufacture, packaging, distribution, use, maintenance, repair, reuse, reco

Scope: This document is applicable to insulating aerial devices for mounting on a chassis, to be used for live working on electrical installations at nominal voltages above 1 000V r.m.s. AC in the range 45 Hz to 65 Hz and 1 500V DC. The primary purpose of an aerial device is for work positioning of personnel. Other devices, such as jibs, may be fitted in order to assist the operator in performing the work. This document also includes requirements and tests for the parts of the chassis influencing the performance of the insulating aerial devices to be used for live working. When mounted on a chassis, the insulating aerial device becomes a component of a mobile elevating work platform (MEWP). Complementary requirements for the resulting MEWP are included in ISO 16368. NOTE 1 In Europe, EN 280 instead of ISO 16368 is often used as reference for complementary requirements. The products designed and manufactured according to this document contribute to the safety of users, provided they are used by skilled persons, in accordance with safe methods of work and the instructions for use. NOTE 2 Any requirements that are in conflict with or are meant to be complementary to ISO 16368 are delineated herein. Radial boom (digger) derricks are not covered by this document.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61057-2017 PDF

IEC 61057-2017 PDF

$239.59 $479.18