Industrial-process measurement, control and automation – Evaluation of system properties for the purpose of system assessment – Part 1: Terminology and basic concepts
Introduction: IEC 61069 deals with the method which should be used to assess system properties of a basic control system (BCS). IEC 61069 consists of the following parts: Part 1: Terminology and basic concepts Part 2: Assessment methodology Part 3: Assessment of system functionality Part 4: Assessment of system performance Part 5: Assessment of system dependability Part 6: Assessment of system operability Part 7: Assessment of system safety Part 8: Assessment of other system properties Assessment of a system is the judgement, based on evidence, of the suitability of the system for a specific mission or class of missions. To obtain total evidence would require complete evaluation (for example under all influencing factors) of all system properties relevant to the specific mission or class of missions. Since this is rarely practical, the rationale on which an assessment of a system should be based is: the identification of the importance of each of the relevant system properties; the planning for evaluation of the relevant system properties with a cost-effective dedication of effort to the various system properties. In conducting an assessment of a system, it is crucial to bear in mind the need to gain a maximum increase in confidence in the suitability of a system within practical cost and time constraints. An assessment can only be carried out if a mission has been stated (or given), or if any mission can be hypothesized. In the absence of a mission, no assessment can be made; however, exa
Scope: This part of IEC 61069 defines the terminology and outlines basic concepts in the assessment of a basic process control system (BPCS) and a basic discrete control system (BDCS). These two general system types cover the areas of discrete, batch and continuous applications. In IEC 61069 these two, BPCS and BDCS, together are referred to as "basic control system(s)", (BCS). The treatment of safety in IEC 61069 is confined to hazards that can be present within the BCS itself. Considerations of hazards that can be introduced by the process or equipment under control, of the BCS to be assessed, are excluded. Where the BCS risk reduction is intended to be less than 10 (i.e. SIL < 1, per IEC 61508-4), then assessment comes under IEC 61069. A BCS with a safety integrity level (SIL) or performing any safety instrumented function (SIF) is not covered by IEC 61069, where SIL is defined by IEC 61508-4 and SIF is defined by IEC 61511-1. This part of IEC 61069 is intended for the users and manufacturers of systems, and also for those who are responsible for carrying out assessments as an independent party.
Contents:
- FOREWORD
- INTRODUCTION
- Scope