Connectors for electrical and electronic equipment – Product requirements – Part 2-116: Detail specification for circular connectors size 15 with up to 3+PE power contacts and auxiliary contacts, with bayonet-locking
Introduction: IEC SC 48B – Electrical connectors Specification available from: IEC General secretariat or from the addresses shown on the inside cover. IEC 61076-2-116 Ed. 1 DETAIL SPECIFICATION in accordance with IEC 61076-1 Circular connectors for signal and power applications with bayonet- locking Male and female connectors Male and female contacts Rewireable and non-rewireable Free cable connectors Straight and right-angle connectors Fixed connectors Flange mounting Single hole mounting With circular mounting orientation The International Electrotechnical Commission (IEC) draws attention to the fact that it is claimed that compliance with this document may involve the use of a patent concerning the connector type 3 given in 5.2.4.3. IEC takes no position concerning the evidence, validity and scope of this patent right. The holder of this patent right has assured the IEC that he/she is willing to negotiate licences either free of charge or under reasonable and non-discriminatory terms and conditions with applicants throughout the world. In this respect, the statement of the holder of this patent right is registered with IEC. Information may be obtained from: LQ Mechatronik-Systeme GmbH Carl-Benz-Strasse 6 Besigheim, Germany 74354 Attn: Mr. Friedrich P. Link ISO (www.iso.org/patents) and IEC (http://patents.iec.ch) maintain on-line data bases of patents relevant to their standards. Users are encouraged to consult the data bases for the most up to date information concerning patents.
Scope: This part of IEC 61076-2 specifies circular connectors size 15 with bayonet-locking, with up to 3 power contacts with rated insulation voltage up to 630 V AC/DC and rated current up to 20 A, plus PE, and up to 3 auxiliary contacts with rated insulation voltage up to 63 V AC/DC and rated current up to 10 A, that are typically used for industrial power supply and power applications, such as the feeding and control of 3-phase asynchronous motors. These connectors consist of both fixed and free connectors either rewireable or non-rewireable, with bayonet-locking. Male connectors have round contacts, either power or signal, Ø1,6 mm. NOTE 1 Size 15 is the dimension of the inner contact carrier of the male connector interface (dimension AG in Table 18). NOTE 2 Number of power and auxiliary contacts, voltage and current ratings vary according to the type of connector, see Table 1.
Contents:
- FOREWORD
- INTRODUCTION
- Scope