Instruments and software used for measurements in high-voltage and high-current tests – Part 1: Requirements for instruments for impulse tests
Introduction: The electric power industry requires standardized tools to provide confidence in high-voltage and high-current testing results, and to prove equivalence between tests performed in different test facilities. Analogue capture of test data has today been largely replaced by digital capture with recording instruments based on sampling technology. This part of IEC 61083 specifies requirements for the performance of digital recorders used for high-voltage and high-current impulse tests. Since the last revision of this standard, significant improvements have been made in many aspects of digitising instruments used for high-voltage and high-current tests. In particular, digitising resolutions have improved several folds since the last revision, with 12-bit to 14-bit being typical resolutions for impulse measurement digitisers. Furthermore, the improvement of A/D converters has led to a situation where other aspects of the instruments, such as linearity of front-end amplifiers and performance of immunity to interference, have replaced performance of A/D converters as the main concern of measurement accuracy and instrument reliability. The requirements in this edition of the standard have been revised to reflect these technological changes. For example, the number of type tests aimed for evaluating the performance of A/D converters has been reduced, and new requirements for the linearity of complete system (A/D converter and analogue components) have been added. During preparation of t
Scope: This part of IEC 61083 is applicable to digital recorders, including digital oscilloscopes, used for measurements during tests with high impulse voltages and high impulse currents. It specifies the measuring characteristics and calibrations required to meet the measuring uncertainties and procedures specified in IEC 60060-2 and IEC 62475. This document defines the terms specifically related to digital recorders; specifies the necessary requirements for such instruments to ensure their compliance with the requirements for high-voltage and high-current impulse tests; establishes the tests and procedures necessary to demonstrate their compliance; covers digital recorders that permit access to raw data from permanent or temporary storage; covers peak meters used for measuring the extreme value of lightning impulses, the peak value of switching or current impulses. It has the status of a horizontal standard in accordance with IEC Guide 108. This horizontal standard is primarily intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 108. One of the responsibilities of a technical committee is, wherever applicable, to make use of horizontal standards in the preparation of its publications. The contents of this horizontal standard will not apply unless specifically referred to or included in the relevant publications.
Contents:
- FOREWORD
- INTRODUCTION
- Scope