IEC 61086-1-2004 PDF

IEC 61086-1-2004 PDF

Coatings for loaded printed wire boards (conformal coatings) Part 1: Definitions, classification and general requirements

$15.77 $31.53 -50%
Product Code: IEC 61086-1
Stock In Stock
Edition: 2.0
Published: 01/2004
Number of Pages: 22
File Size: 1 file, 432 Bytes

Available Options

Product Description

Coatings for loaded printed wire boards (conformal coatings) Part 1: Definitions, classification and general requirements

Introduction: This International Standard forms part of a series published under the general title Coatings for loaded printed wire boards (conformal coatings). The series consists of three parts: Part 1: Definitions, classification and general requirements (IEC 61086-1) Part 2: Methods of tests (IEC 61086-2) Part 3: Specifications for individual materials (IEC 61086-3)

Scope: This part of IEC 61086 gives the definitions, classification and general requirements for electrical insulating materials suitable for application as coatings for loaded printed wire boards (conformal coatings). This standard excludes requirements for compatibility between such coatings and printed wire boards, this characteristic being evaluated in individual applications. Surface modifiers are not classified as conformal coatings. They only provide a thin film that does not cure and has low mar resistance. They are excluded from this standard. Materials which conform to this standard meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this standard alone. Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 conformal coating electrical insulating material applied as a coating to loaded printed wire boards to produce a thin layer conforming to the surface in order to provide a protective barrier against deleterious effects from environmental conditions 2.2 surface modifier non-curing hydrophobic material, applied as a surface layer of thickness 1 µm to 2 µm to a loaded printed wiring board to protect against deleterious effects from environmental conditions by changing the surface characteristics 2.3 oligomeric oligomeric blended material derived from a low molecular mass acrylic material and other low molecular mass reactive materials (for example, polyester, epoxy, etc.), possibly with other additions to give specific properties Classification The types of conformal coatings covered by this standard shall be identified according to a code consisting of: Number: indicating the classification of the material; Letter: indicating the resin type, and Suffix number distinguishing between the variants of each of the resin types.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61086-1-2004 PDF

IEC 61086-1-2004 PDF

$15.77 $31.53