Electromechanical contactors for household and similar purposes
Introduction: This document gives requirements for contactors household and similar purposes, including contactors for distribution control in buildings. Contactors for such purposes have particular requirements which include test sequences and sampling plans to facilitate testing. Contactors according to this document are limited in the range of operational currents and operational voltages to values appropriate to the applications. Such contactors are for use in circuits of limited prospective short-circuit fault current for which they are co-ordinated with an appropriate short-circuit protective device to provide suitable co-ordination. This document defines in a single document the specific utilization category for a described application and states the relevant requirements. As far as possible, it is in line with the requirements contained in IEC 60947-4-1. This document also applies to contactors which are components of an appliance, unless otherwise stated in the standard covering the relevant appliance.
Scope: This document applies to electromechanical air break contactors for household and similar purposes provided with main contacts intended to be connected to circuits the rated voltage of which does not exceed 440 V AC (between phases) with rated operational currents less than or equal to 63 A for utilization category AC-7a, and 32 A for utilization categories AC-7b, AC-7c and AC-7d (expressed in rated power), and rated conditional short-circuit current less than or equal to 6 kA. NOTE Today, most LED lamp manufacturers provide information in Watt. So, the main contactor characteristic for utilization category AC-7d is expressed in Watt to be directly applicable to the corresponding LED lamp load. Specific requirements apply to contactors equipped with screwless-type terminals. This document does not apply to contactors complying with IEC 60947-4-1; semiconductor contactors; contactors designed for special applications; auxiliary contacts of contactors. These are dealt with in IEC 60947-5-1. This document states 1) the characteristics of contactors. 2) the conditions with which contactors comply with reference to: a) their operation and behaviour; b) their dielectric properties; c) the degrees of protection provided by their enclosures, where applicable; d) their construction; e) their electromagnetic compatibility characteristics. 3) the tests intended for confirming that these conditions have been met, and the methods to be adopted for these tests. 4) the test sequences and the number of samples. 5) the information to be given with contactors or in the manufacturer's literature.
Contents:
- FOREWORD
- INTRODUCTION
- Scope