IEC 61124-2023 PDF

IEC 61124-2023 PDF

Reliability testing-Compliance tests for constant failure rate and constant failure intensity

$255.36 $510.71 -50%
Product Code: IEC 61124
Stock In Stock
Edition: 4.0
Published: 02/2023
Number of Pages: 186
File Size: 1 file, 4 Bytes

Available Options

Product Description

Reliability testing – Compliance tests for constant failure rate and constant failure intensity

Introduction: A compliance test is an essential part of the reliability assurance system [7], [8], [9]. Reliability is affected by many random factors, so its prediction is not accurate. The direct way to check if the item meets its reliability specifications is to perform a compliance test. The tests described in this document can be applied to items that have a failure rate or failure intensity (denoted by λ) which can be considered as a constant. The procedures are based on the assumption that trials of the test are statistically independent. If it is necessary to test the constant failure rate and constant failure intensity assumption, the procedures given in IEC 60605-6 should be used. The test serves to verify the compliance with a specified λ0, that is, to verify that λ ≤ λ0. The probability of making the correct decision in the test depends on the test duration and on the sample size (number of failures). The tests usually require a large sample size and, accordingly, a large consumption of time and funds. The consumptions are especially high for reliability testing. For this reason, sampling plans of the tests should be carefully planned in order to reduce the consumption. This document is dedicated to sampling plans for the tests. The tests are characterized by the operating characteristic (OC) and test duration until the test stops with the accept/reject decision on the compliance. OC is the probability of accepting an item as meeting the requirements. In this document, the OC i

Scope: This document gives a number of optimized test plans, the corresponding border lines and characteristics. In addition, the algorithms for designing test plans using a spreadsheet program are also given, together with guidance on how to choose test plans. This document specifies procedures to test whether an observed value of failure rate, failure intensity, mean operating time to failure (MTTF), mean operating time between failures (MTBF), conforms to a given requirement. It is assumed, except where otherwise stated, that during the accumulated test time, the times to failure or the operating times between failures are independent and identically exponentially distributed. This assumption implies that the failure rate or failure intensity is assumed to be constant. Four types of test plans are described as follows: truncated sequential probability ratio test (SPRT); fixed time/failure terminated test (FTFT); fixed calendar time terminated test without replacement; combined test. This document does not cover guidance on how to plan, perform, analyse and report a test. This information can be found in IEC 60300-3-5. This document does not describe test conditions. This information can be found in IEC 60605-2 and in IEC 60300-3-5.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61124-2023 PDF

IEC 61124-2023 PDF

$255.36 $510.71