Multicore and Symmetrical Pair/Quad Cables for Digital Communications - Part 1-1: Capability Approval - Generic Specification
Introduction: Quality systems are intended to give confidence to the customers. It is presumed that a supplier whose full organization complies with ISO 9000 is able to assess the quality of his services (services can be a product). However, to assess the quality of the services is obviously not sufficient from a customer point of view. The customer's concern is the quality of the product. That means the compliance to a given specification. The IEC Quality Assessment System for Electronic Components (IECQ), product/process Approval Procedures, Qualification Approval (QA), Capability Approval (CA) and Technology Approval (TA) are intended to ensure that all products delivered under one of them will comply to a given specification. These procedures are described in IEC QC 001002-3:1998. As a first step, to achieve this task, the three procedures just mentioned require as a prerequisite manufacturer’s approval (described in IEC QC 001002-3, clause 2 and which is basically an ISO 9000 approval with the relevant technical scope, plus IECQ requirements as defined in 2.3.2 of IEC QC 001002-3). Manufacturer’s approval ensures that all the actions taken for Qualification Approval, Capability Approval or Technology Approval will be under control and well documented. The second step is the Qualifying Stage sometimes called Type Approval. In case of Qualification Approval (QA), the purpose of this stage is to demonstrate the validity of the design file of a given product (ideally the design file shoul
Scope: This part of IEC 61156 which is a generic specification applies to Capability Approval requirements for multicore and symmetrical pair/quad cables for digital communications as specified in IEC 61156-1 series. It specifies the requirements for a manufacturer seeking approval of his capability to design (if applicable), manufacture, inspect, test and release multicore and symmetrical pair/quad cables for digital communications as defined in his Capability Manual. The manufacturer’s approval, which embodies all the relevant requirements of ISO 9001 and ISO 9002, is a prerequisite for granting Capability Approval but a manufacturer may apply for manufacturer’s approval and Capability Approval concurrently. NOTE 1 This standard was written, to be used in case of a third party certification. However, it may be used as the basis for a second party or for self-certification. NOTE 2 When certification is required, Capability Approval should be used according to that which is indicated below. It may also be used for a second party or for self-certification. 1.2