Metal halide lamps – Performance specification
Introduction: A big step forward when standardising metal halide lamps and their operation was made with the second edition which was published in 2011. Meanwhile, agreements were reached for the introduction of new lamp types and in aspects of operation which led to the third edition. Major changes in the second edition were as follows. Since IEC 62035 was published in 1999, the related lamp specific performance standards such as IEC 61167 needed to be reviewed in an editorial action, splitting performance and safety requirements, but also to include all items in abeyance, stored for this occasion. The separation had already been carried out with other HID lamps. So, in some instances, the “pilot” text of IEC 60188 was used. Moreover, the measurement part was introduced with the assistance of IEC 60188 and IEC 60081. It may also be noted that the colour coordinates for CCT 3 000 K and 4 200 K were adjusted to a point two units below Planck in order to take account of the life time shift to higher y- values. Apart from these basic changes which had been needed for a long time, the new technique of low frequency square wave (LFSW) operation was implemented. This led to additional pages to the existing lamp data sheets and several annexes describing and specifying the requirements. Further, detailed requirements and measurement methods for the ignition (break down/take-over/run-up) were introduced. Intense discussions took place on measurement and specification of the peak-current ratio duri
Scope: This document specifies the performance requirements for metal halide lamps for general lighting purposes. For some of the requirements given in this document, reference is made to “the relevant lamp data sheet”. For some lamps, these data sheets are contained in this document. For other lamps, falling under the scope of this document, the relevant data are supplied by the lamp manufacturer or responsible vendor. The requirements of this document relate only to type testing. The requirements and tolerances specified in this document correspond to testing of a type test sample submitted by the manufacturer for that purpose. In principle this type test sample consists of units having characteristics typical of the manufacturer’s production and being as close to the production centre point values as possible. It can be expected that with the tolerances given in this document, the product manufactured in accordance with the type test sample will comply with this document for the majority of production. Due to the production spread however, it is inevitable that there will sometimes be products outside the specified tolerances. For guidance on sampling plans and procedures for inspection by attributes, see ISO 2859-10.
Contents:
- FOREWORD
- INTRODUCTION
- Scope