IEC 61188-1-1-1997 PDF

IEC 61188-1-1-1997 PDF

Printed Boards and Printed Board Assemblies - Design and Use - Part 1-1: Generic Requirements - Flatness Considerations for Electronic Assemblies

$25.22 $50.44 -50%
Product Code: IEC 61188-1-1
Stock In Stock
Edition: 1.0
Published: 08/1997
Number of Pages: 36
File Size: 1 file, 114 Bytes

Available Options

Product Description

Printed Boards and Printed Board Assemblies - Design and Use - Part 1-1: Generic Requirements - Flatness Considerations for Electronic Assemblies

Introduction: Rigid printed board technology demands a high degree of flatness in substrates and assemblies and distortion may result from a number of causes. All individuals involved at any stage of design, manufacture and use shall be aware of and understand the potential problems. It is essential that they pay specific attention to those factors under their control. The following table shows the references to the three test methods given in IEC 61189-2. Bow and twist test method checklist for materials Parameter Condition IEC 61189-2 Test No. Bow Bow Twist Twist As received After processing As received After processing 2M01 2M02 2M01 2M04

Scope: This part of IEC 61188 describes those factors which control the flatness of rigid printed boards and their assemblies. The object of this standard is to inform the designer, manufacturer, assembler and user of rigid printed boards and their assemblies about those factors affecting their flatness. This standard incorporates advice regarding: design (clause 3); base material (clause 4); unassembled printed boards (clause 5); printed board assemblies (clause 6).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 3.1 Design
  • 3.2 Rigid board manufacture
  • 3.3 Assembly
  • 3.4 Use
  • 4.1 Causes
  • 4.2 Prevention and correction
  • 4.3 Test methods and requirements
  • 5.1 Causes
  • 5.2 Prevention
  • 5.3 Rectification
  • 5.4 Requirements for flatness
  • 5.5 Measurement methods
  • 6.1 Causes
  • 6.2 Prevention
  • 6.3 Correction
  • 7.1 Placement of components (assembly)
  • 7.2 Requirements for "pick-and-place" machines
  • 10 Corrective action summary

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61188-1-1-1997 PDF

IEC 61188-1-1-1997 PDF

$25.22 $50.44