IEC 61188-6-3-2024 PDF

IEC 61188-6-3-2024 PDF

Circuit boards and circuit board assemblies-Design and use-Part 6-3: Land pattern design-Description of land pattern for through hole components (THT)

$163.93 $327.86 -50%
Product Code: IEC 61188-6-3
Stock In Stock
Edition: 1.0
Published: 12/2024
Number of Pages: 66
File Size: 1 file, 3 Bytes

Available Options

Product Description

Circuit boards and circuit board assemblies – Design and use – Part 6-3: Land pattern design – Description of land pattern for through hole components (THT)

Introduction: The new series IEC 61188-6-xx replaces the below listed documents: IEC 61188-5-1:2002, Printed boards and printed board assemblies – Design and use – Part 5-1: Attachment (land/joint) considerations – Generic requirements IEC 61188-5-2:2003, Printed boards and printed board assemblies – Design and use – Part 5-2: Attachment (land/joint) considerations – Discrete components IEC 61188-5-3:2007, Printed boards and printed board assemblies – Design and use – Part 5-3: Attachment (land/joint) considerations – Components with gull-wing leads on two sides IEC 61188-5-4:2007, Printed boards and printed board assemblies – Design and use – Part 5-4: Attachment (land/joint) considerations – Components with J leads on two sides IEC 61188-5-5:2007, Printed boards and printed board assemblies – Design and use – Part 5-5: Attachment (land/joint) considerations – Components with gull-wing leads on four sides IEC 61188-5-6:2003, Printed boards and printed board assemblies – Design and use – Part 5-6: Attachment (land/joint) considerations – Chip carriers with J-leads on four sides IEC 61188-5-8:2007, Printed boards and printed board assemblies – Design and use – Part 5-8: Attachment (land/joint) considerations – Area array components (BGA, FBGA, CGA, LGA) The content of the above documents is based on IPC-SM-782 Rev. A with Amendments 1 and 2, which was replaced in 2002 by IPC-7351. The component spectrum and pitch levels have dramatically changed since publication of the 61188-5-xx series an

Scope: This part of IEC 61188 specifies the requirements for lands and land pattern on circuit boards for the mounting of components with leads by soldering based on the solder joint requirements of IEC 61191-1 and IEC 61191-3. This part of IEC 61188 specifies the requirements for soldering surfaces on circuit boards. This includes lands and land pattern for surface mounted components and also solderable hole configurations for through hole mounted components. These requirements are based on the solder joint requirements of IEC 61191-1, IEC 61191-2, IEC 61191-3 and IEC 61191-4.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61188-6-3-2024 PDF

IEC 61188-6-3-2024 PDF

$163.93 $327.86