IEC 61191-6-2010 PDF

IEC 61191-6-2010 PDF

Printed board assemblies-Part 6: Evaluation criteria for voids in soldered joints of BGA and LGA and measurement method

$163.93 $327.86 -50%
Product Code: IEC 61191-6
Stock In Stock
Edition: 1.0
Published: 01/2010
Number of Pages: 80
File Size: 1 file, 2 Bytes

Available Options

Product Description

Printed board assemblies – Part 6: Evaluation criteria for voids in soldered joints of BGA and LGA and measurement method

Introduction: The necessity for the evaluation of voids in soldered joints increases in the industry because the voids may affect the reliability of joints as the devices get smaller. As the number of interconnections increases the reliability per joint must also increase. This subject has been discussed in some countries and trade organizations, and specific proposals have been made for classification or evaluation of voids to develop process guidelines. The same subject is also studied in academia to find correlation between voids and reliability of a joint. Appreciable findings are now available from the reliability study including relation between shapes of voids and degradation of life due to voids in a joint in thermal cycle stress. Based on the information available, we developed evaluation criteria of voids in soldered joints for BGA (Ball Grid Array) and LGA (Land Grid Array) and a measurement method.

Scope: This part of IEC 61191 specifies the evaluation criteria for voids on the scale of the thermal cycle life, and the measurement method of voids using X-ray observation. This part of IEC 61191 is applicable to the voids generated in the solder joints of BGA and LGA soldered on a board. This part of IEC 61191 is not applicable to the BGA package itself before it is assembled on a board. This standard is applicable also to devices having joints made by melt and re-solidification, such as flip chip devices and multi-chip modules, in addition to BGA and LGA. This standard is not applicable to joints with under-fill between a device and a board, or to solder joints within a device package. This standard is applicable to macrovoids of the sizes of from 10 µm to several hundred micrometres generated in a soldered joint, but is not applicable to smaller voids (typically, planar microvoids) with a size of smaller than 10 µm in diameter. This standard is intended for evaluation purposes and is applicable to research studies, off-line production process control and reliability assessment of assembly

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61191-6-2010 PDF

IEC 61191-6-2010 PDF

$163.93 $327.86