IEC 61193-1-2001 PDF

IEC 61193-1-2001 PDF

Quality Assessment Systems - Part 1: Registration and Analysis of Defects on Printed Board Assemblies

$100.88 $201.76 -50%
Product Code: IEC 61193-1
Stock In Stock
Edition: 1.0
Published: 12/2001
Number of Pages: 50
File Size: 1 file, 1020 Bytes

Available Options

Product Description

Quality Assessment Systems - Part 1: Registration and Analysis of Defects on Printed Board Assemblies

Introduction: This part of IEC 61193 enables the counting of defects on soldered printed board assemblies in the manufacture of electronic circuits and the associated calculation of ppm (parts per million) data to be carried out in a standard manner. The number of defects occurring during the production process is usually expressed at lower defect levels in parts per million, commonly indicated as ppm. On the face of it, the meaning of the ppm value of a soldering process is self-evident: a part is, in this context, a soldered joint that is defective, the million refers to a million soldered joints. For a uniform registration of defects it is emphasized that in this standard the soldering defects are counted immediately after the actual soldering operation (on emergence of the soldered assembly from the soldering machine). By the Pareto analysis method it can be assessed whether the defect should be attributed to the soldering process proper or to another cause. In order to manage the ppm values to be calculated, there is a need to understand the mathematical significance of the number of defects found in a batch of a particular size (i.e. smaller than the size of the entire lot of products) and its consequences for the entire lot. Mentioning the ppm value of a certain soldering process, without reference to the number of soldered joints and without giving the level of confidence is of little use. For making ppm calculations, several methods are described by which the maximum ppm level to

Scope: This part of IEC 61193 defines methods of registration and analysis of defects on soldered printed board assemblies. Methods are described to allow effective comparison of perform- ance between products, processes and production locations and can serve as a basis for general quality improvement. The standard specifies defect data collection in two categories. Category 1 ppm data: this category provides data for registration purposes intended to enable overall performance comparison of assembly operations. Category 2 ppm data: this category provides data intended for individual subprocess assessment, analysis and control purposes.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61193-1-2001 PDF

IEC 61193-1-2001 PDF

$100.88 $201.76