IEC 61193-3-2013 PDF

IEC 61193-3-2013 PDF

Quality assessment systems-Part 3: Selection and use of sampling plans for printed board and laminate endproduct and in-process auditing

$239.59 $479.18 -50%
Product Code: IEC 61193-3
Stock In Stock
Edition: 1.0
Published: 01/2013
Number of Pages: 140
File Size: 1 file, 1 Byte

Available Options

Product Description

Quality assessment systems – Part 3: Selection and use of sampling plans for printed board and laminate endproduct and in-process auditing

Introduction: A clear description in IEC standards and specifications and their reference to sampling plans in order to insure adherence to customer requirements is essential. All the details should be clear as to their implementation or adjustment for evaluation of the product to be shipped, the use of process control and SPC, or the applicability for using these principles in controlled experimentation. The general characteristics of these principles relate to a gradual reduction that might be needed in examining the product being manufactured. As such, they are sometimes referred to as the logical steps to process improvement. These steps are as follows. a) STATISTICAL SAMPLING: where, when, and why To determine a proper amount of examples from a given lot of product and using statistics to evaluate the occurrence of anomalies. b) ZERO DEFECT STANDARDS: role of specifications To adopt the role of attempting to achieve no defects in a production lot through the recommendations identified in standards or specifications that define the product requirements. c) ECONOMICS: AQL versus cost of defects To establishing the highest level of non-conforming product characteristics, determining the cost that is incurred when these are discovered or delivered accidentally to the customer (cost of quality) and establishing an acceptable quality assessment methodology in order to reduce these occurrences. d) SPC REDUCED INSPECTION: rules for use and control To create a process control program that is b

Scope: This part of IEC 61193 establishes sampling plans for inspection by attributes, including sample plan selection criteria and implementation procedures for printed board and laminate end-product and in-process auditing. The principles established herein permit the use of different sampling plans that may be applied to an individual attribute or set of attributes, according to classification of importance with regard to form, fit and function.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61193-3-2013 PDF

IEC 61193-3-2013 PDF

$239.59 $479.18