IEC 61223-2-7-1999 PDF

IEC 61223-2-7-1999 PDF

Evaluation and Routine Testing in Medical Imaging Departments - Part 2-7: Constancy Tests - Equipment for Intra-Oral Dental Radiography Excluding Dental Panoramic Equipment

$100.88 $201.76 -50%
Product Code: IEC 61223-2-7
Stock In Stock
Edition: 1.0
Published: 09/1999
Number of Pages: 28
File Size: 1 file, 105 Bytes

Available Options

Product Description

Evaluation and Routine Testing in Medical Imaging Departments - Part 2-7: Constancy Tests - Equipment for Intra-Oral Dental Radiography Excluding Dental Panoramic Equipment

Scope: This part of IEC 61223 applies to RADIOLOGICAL INSTALLATIONS with diagnostic X-ray systems designed to expose intra-orally placed radiographic films or electronic equipment (sensors), but excluding dental panoramic equipment. This standard is a part of a series of Particular Publications (standards and technical reports), which give methods of tests for the constancy of operation of various subsystems of diagnostic X-RAY EQUIPMENT. This part of IEC 61223 is designed to be applicable to equipment for intra-oral dental radiography without digital imaging devices. 1.2 Object This standard describes a method to check, in terms of functional parameters, that the constancy of the quality of images produced by intra-oral dental X-RAY EQUIPMENT is maintained after installation, calibration and adjustment have been carried out. This standard defines the functional parameters, which describe the performance of X-RAY EQUIPMENT for intra- oral dental radiographic examination; methods of checking, whether variations in measured functional parameters meet ESTABLISHED CRITERIA, in order to ensure that the conditions for adequate imaging performance are maintained, while unnecessary IRRADIATION of the PATIENT is avoided. The methods are based upon assessment of radiographic information using an appropriate TEST DEVICE. The purpose of the methods is to establish a reference level of performance following an ACCEPTANCE TEST and an initial CONSTANCY TEST; to detect and verify any significant variation in functional parameters which may then require corrective actions. Because RADIOLOGICAL INSTALLATIONS differ widely from each other, it is not possible in this standard to specify target values and tolerances for the parameters which would be generally applicable as criteria of acceptable performance. Guidance is given, however, as to the degree of variation in single measurements which might require appropriate action. This standard gives methods of tests for the constancy of properties of diagnostic X-RAY EQUIPMENT as described in IEC 61223-1 (see clause 2). – 6 – 61223-2-7 © IEC:1999(E) This standard is not intended to deal with: aspects of mechanical or electrical safety; checks

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61223-2-7-1999 PDF

IEC 61223-2-7-1999 PDF

$100.88 $201.76